Display During Operation
Appears when a disc is loaded on the
No disc inserted / cannot read disc.
disc tray.
Appears when a disc or tape is being
Appears when the disc tray is opening.
played back.
Appears when the PBC function is acti-
Appears when the disc tray is closing.vated (Video CD playback only. Refer
to page 5).
Rear Terminals
AERIAL
RF OUT
212223 24 25262728 29
21. MAIN (AC power cord)26. EURO AV1 (TV) Terminal
Connect to a standard AC plug.Use the scart cable to connect this terminal to the 21-pin scart
terminal on your A/V-compatible TV or wide screen TV for a best
22. COMPONENT VIDEO OUT Jacks (DVD only)
quality picture.
Connect optional component video cable here through the com-
ponent video input jacks of a TV.27. EURO AV2 (DECODER) Terminal (VCR only)
Use the scart cable to connect this terminal to the 21-pin scart
23. COAXIAL DIGITAL AUDIO OUT Jack (DVD only)
terminal on your decoder.
Connect to a compatible Dolby Digital receiver.
ETUP
Use to connect to a Dolby Digital, DTS, or MPEG decoder.28. RF OUT Jack
S
Use the supplied Round Coaxial cable to connect this jack to the
24. ANALOG AUDIO OUT Jacks (Left/Right) (DVD only)
AERIAL jack on your TV.
Connect to the audio input jacks of A/V-compatible TV.
29. AERIAL Jack
25. S-VIDEO OUT Jack (DVD only)
Connect your antenna, cable box, or direct broadcast system.
Use the S-video cable to connect this jack to the S-video input
jack on your A/V-compatible TV or wide screen TV for a higher
quality picture.
VCR/DVD SWITCHING
Because this product is a combination of a VCR and a DVD player,
you must select first which component you wish to operate with DV-NC230
OPERATEOPEN/CLOSEOPERATE
OUTPUT.DISPLAYSETUP OPEN/CLEJECTOSE
PULL OPENREWFFSTEJECTOP/ PLAYRECTIMERCHVCROUTPUTDVDSTOPPLAYSUBTITLEANGLEAUDIOMARKER
(TRACKING)
VCR MODEZOOMVCRDVDMODE
Press VCR on the remote control.TITLEMENU
VCR button
(Verify that the VCR OUTPUT indicator is lit.)RETURNENTER
DVD buttonREPEAT
123
DVD MODEA-B REPEAT
456
OUTPUT
Press DVD on the remote control.
VCRDVD789CLEAR/C-RESETSKIP
(Verify that the DVD OUTPUT indicator is lit.)0+10
DVD OUTPUT REVFWD
indicatorPLAY
REC/OTRSTILL/PAUSE
HintSTOP
OUTPUT buttonDIREC
QUICKT SKIP-FINDTA/SYPE SPEEDSTEM ON/OFFTIMERSLOW
Pressing only OUTPUT on the front panel DOES NOT switch the
mode of the remote control. You MUST select the correct mode GAMMA SEARCH MODECH
on the remote control.
VCR OUTPUT In the wrong mode, the VCR/DVD does not respond to your com-
mands correctly. Before starting your desired operation, select indicator
the correct mode by following the instruction (1472508VCR36+109STOPPLAYDVDpress first. or
1472508VCR369DVDVCR/DVD COMBINANA527ADTION+10VCR/DVD CNA545FDOMBINATION
STOPPLAYpress first.) under the subject heading.
VCR/DVDNA527AD COMBINATION
? 7 ?EN |
ACEC
