VCR Setup
Setting the Language
This Product is factory preset to display the LANGUAGE setting
screen after VCR MENU is pressed when the Product is operated for
the first time. In some cases, the retailer may have already set the
G-CODE
language, and the CLOCK setting screen will appear after VCRDV- NC70W
MENU is pressed. To reset the Product, perform the following steps.DV- NC70PROG
DV- NC70X
VCR-RESET
TIMER
1Press OPERATE to POWER OFF on the Product.OPERATEON/OFFEJECT
2Press OPERATE to POWER ON on the Product.ONVCR/DVDVCR MENU
DISPLAYSCREENSELECTORDVD SETUP
3Press VCR MENU and CH " on the Remote at the same timeFUNCTIONPROG/OPEN/
CONTROLREPEATANGLE CLOSE
for five seconds. (The LANGUAGE setting screen should appear.)
TITLEDVD MENU
" When the Product is reset, all channel settings, guide channel settingCLEAR RETURNSETENTER
for the G-CODE system and timer setting will be cancelled.
ZERO BACK
Initial Setting of LanguageSKIP SEARCH
Preparation
" Press OPERATE . Then move the VCR/DVD CHANGE Switch toAM/PMINPUT SELECTVCR DVD
VCR ./
REVFWD
1Press '/" to select the language and press SET to confirm.
PLAY
LANGUAGE
RECPAUSE/STILL
ENGLISH
STOP
TAPEDPSS
SPEEDSKIPSLOW
AUDIO
CHOUTPUT
Changing Language
VCRDVD
If the language has already been set previously and you want to
change it, follow the steps below.
1Press VCR MENU. Press '/" to select OLANGUAGE � and
press SET to confirm.
VCR/DVD COMBINATION
MENU
G-CODE
TIMER
MODE
CHANNEL PRESET
CLOCK
LANGUAGE
:SELECT
SET:ENTER MENU:EXIT
2Select the language with '/" and press SET to confirm.
LANGUAGE
ENGLISH
3Press VCR MENU to return to the normal screen.
37GB |
ACEC
