TV Programme Recording
Cassette Erase Protection
ERASURE
A , cassette has a removable tab to prevent accidentalPROTECTION TAB
PAL SECAM
erasure of recorded material. Removing the tab prevents recording.
To record on a video cassette with the tab removed, place adhesive
tape over the tab opening.
Recording a TV Programme
Preparation
" Press OPERATE. Then move the VCR/DVD CHANGE Switch to
VCR.
" Ensure the Video channel is selected on the TV.
OPERATETIMER
1Insert the cassette, making sure the erasure protection hole isON/OFFPROGEJECT
covered.
ONVCR/DVDVCR MENU
DISPLAYSCREENSELECTORDVD SETUP
2Select the channel position you wish to record with CH ' / ".FUNCTIONPROG/OPEN/ANGLE
CONTROLREPEAT CLOSE
TITLEDVD MENU
3 Select the SP (Standard Play), EP (Extended Play) or LP (Long
Play) recording speed with TAPE SPEED on the Remote (OSP�,
CLEAR SET
RETURNENTER
OEP� or OLP� will light up on the VCR Front Panel display.) SP
(Standard Play) gives the best picture quality, EP (Extended
ZERO BACK
Play) gives the triple recording time and LP (Long Play) gives
the double recording time.SKIP SEARCH
" If the COLOUR mode is set to OAUTO� or OMESECAM�, when aAM/PMINPUT SELECT VCR DVD
SECAM signal is received and the EP mode is selected, the Product/
will automatically change the EP mode to LP mode.
REVFWD
4Press AAAAAREC. (If the erasure protection hole is uncovered, thePLAY
cassette will be ejected.) To pause during recording, press
RECPAUSE/STILL
PAUSE/STILL. To resume recording, press PAUSE/STILLââ
STOP
again.
TAPEDPSS
SPEEDSKIPSLOW
5To stop recording, press �STOP.
AUDIO
CHOUTPUT
" The pause mode disengages automatically after about 5 minutes, andVCRDVD
the Product enters stop mode.
" To record audio and video from an external source through the
AUDIO/VIDEO terminal on the rear of the Product, press INPUT SELECT
on the Remote to select the AV channel position situated between the
last channel and first channel. (When the AV position is selected, OL1�
VCR/DVD COMBINATION
or OL2� is displayed where a channel position number is usually
displayed.)
" If the TV signals are weak and the picture changes to monochrome,
set the strict colour mode on the MODE selection screen. (See �Mode
Selection� on page 25.) Normally, the colour mode should be set to
OAUTO�.
To Watch Another TV Programme While
Recording
After steps 1 to 4 have been completed, select the programme you
wish to view using the TV tuner. At the end of the tape, your Product
will automatically stop recording, rewind the tape, eject it and then turn
off the power. If a DVD is being played back, the power will not turn off.
GB62 |
ACEC
