Troubleshooting
The following problems do not always denote a malfunction of this Product. Perform the checks listed below
before calling service.
VCR/DVD
ProblemSuggested Solution
" No power" Is the power cord connected properly?
" Is the power cord firmly plugged into the power outlet?
" One of the safety mechanisms may be operating. In this event,
unplug the Product from the power outlet briefly and then plug it in
again.
" The Remote does not work." Are the batteries loaded correctly?
" Are the batteries flat?
" Is the signal emitter on the Remote pointing at the Product?
" Is the Remote too far from the Product, or is there any obstacle
between the Remote and the Product?
" Did the VCR/DVD CHANGE Switch change correctly?
" No picture" Did the VCR/DVD SELECTOR change correctly?
" DEW" See page 2 for information (Condensation).
VCR
ProblemSuggested Solution
" VCR does not record." Cassette erasure protection tab has been removed. Use a different
cassette or place adhesive tape over the tab opening.
" Check if a cassette is loaded.
" Cassette is automatically ejected" Cassette erasure protection tab has been removed. Use a different
when pressing AAAAAREC or TIMERcassette or place adhesive tape over the tab opening.
ON/OFF.
" No colour or poor TV picture during" Make sure all the cables are correctly connected.
normal viewing." Make sure the Product power cord is properly plugged in.
" Set the COLOUR MODE, NTSC MODE, and SYSTEM modes to
match the broadcast system and TV.
" Snowy picture appears on TV during " Press CH ' / " to adjust the tracking or try a different cassette.
playback." The heads may be contaminated with condensed moisture or
magnetic coating from the video tape. (If this is the case, the
heads need to be cleaned. Ask the retailer or a Sharp approved
service centre.)
This Product has a built-in full auto head cleaning mechanism,
however, there are some environments in which head cleaning
cannot be carried out completely.
" No tape movement." Make sure the Product is not in pause/still mode.
" Make sure the tape has not reached the beginning or end.
" Cannot receive NTSC (M)" Make sure that the B/G, I, D/K, M (SYSTEM) setting is set to OM�
broadcasting.when setting the channels.
" No picture appears or colour is not" Make sure the TV is set to the same channel as the Product radio
correct during playback.frequency converter output channel adjuster (CHANNEL).INFORMATION
" Check all connecting cables.OTHER
" Set the COLOUR MODE, NTSC MODE, and SYSTEM modes to
match the tape and TV.
107GB
DVNC85(E)#107_112.p6510703.6.24, 10:08 AM |
ACEC
