[key setup procedure]
CHAPTER 1. SERVICE (SRV) MODE
The SRV key is used for operating in the SRV mode.*2
MRS-2 executed 0Key position set Free kFreeey key setup
*1complete.
0
Disable
1. SRV. reset (Program Loop Reset)
Used to return the machine back to its operational state after a lock-MASTER PRESET ** *
up has occurred.
NOTES:
Procedure
* 1: When the 0 key is pressed, the key of the key number on
?Method 1display is disabled.
1) Turn off the AC switch.* 2: Push the key on the position to be assigned. With this, the key
of the key number on display is assigned to that key position.
2) Set the mode switch tco) pos (SRVition.
* 3: When relocating the keyboard, the PGM 1/2 use standard key
3) Turn on the AC switch.layout.
4) Turn to (SRV) position fcrom (S) posiRVtion.
Key numberKey nameKey numberKey name
?Method 21Numeric key "0"10Numeric key "9"
1) Set the mode switch to PGM2 position.2Numeric key "1"11Numeric key "00"
2) Turn off the AC switch.3Numeric key "2"12Numeric key "000"
4Numeric key "3"13Decimal point key
3) While holding down JOURNAL FEED key and RECEIPT FEED
key, turn on the AC switch.5Numeric key "4"14CL key
Note: When disassembling and reassembling always power up us-6Numeric key "5"15 � key
ing method 1 only. Method 2 will not reset the CKDC4.7Numeric key "6"16ST key
Note: SRV programming job#926-B must be set to "4" to allow PG8MNumeric key "7"17 TL key
program loop reset.9Numeric key "8"
PRG. RESET ** *
3. Reading of the SRV mode program
2. Master reset (All memory clear)List of program reports
There are two possible methods to perform a master reset.JOB#Report name
?MRS-1SRV-mode program full item report (not incl. keyboard
900
Used to clear all memory contents and return machine back to itlsayout)
initial settings. return keyboard back to default. for default keyboardKeyboard layout report (on keys other than dept. keys
layout.950
and direct PLU keys)
ProcedureKeyboard layout report (on dept. keys and direct PLU
951
keys)
1) Turn off the AC switch.
970SRV file programming report
2) Set the MODE switch to the (Sc) posRVition.
3) Turn on the AC switch.
4) While holding down JOURNAL FEED key, turn to (SRV) position
from (SRVc) position.
?MRS-2
Used to clear all memory and keyboard contents.
This reset returns all programming back to defaults. The keyboard
must be entered by hand.
This reset is used if an application needs different keyboard layout
other than that supplied by a normal MRS-1.
Procedure
1) Turn off the AC switch.
2) Set the MODE switch to the (Sc) posRVition.
3) Turn on the AC switch.
4) While holding down JOURNAL FEED key and RECEIPT FEED
key, turn to (SRV) position c) posfrom (SitiRVon.
5) Key position assignment:
* After the execution of MRS-2, only the RECEIPT FEED and
JOURNAL FEED keys can remain effective on key assignment.
Any key can be assigned on any key position on the main key-
board.
ä 1 ä |
ACEC
