MAIN UNIT
To prevent dirt or stains on the main unit, clean as often as necessary. If stains are allowed to
remain, they may become hard to clean.
W ipe with a dry, soft cloth
For stubborn stains or dirt, use a soft cloth dampened with warm water.
Do not use volatile fluids
Benzene, paint thinner, polishing powder, etc., may damage the surface.
Do not use detergents
Detergent ingredients may damage the unit.
Keep the unit away from water
ODOURPRE-FILTER
SENSORRemove the Filter Frame, Clean the top surface of the
Pre-Filter lightly with a vacuum cleaner.
ENGLISH
Remove dust from the sur-If it is contaminated heavily, remove it from the Filter Frame
faces of the sensor open-to wash it.
ings with a vacuum cleaner.
NOTE
Pre-Filter
YIn case of washing, use a soft
brush etc. and cold/warm water.
YMetal brushes or scrub brushes
Odourmay cause damage.
SensorYAfter washing, leave it in the
shade until it gets dried. Then
place it back to the Filter Frame.
SPECIFICATIONS
ModelFU-28H-S
Power supply220-240V 50/60Hz
Fan speed AdjustmentMAXSILENT
Fan speed
Rated Power29 W3.1 W
Operation
33
Air Flow Volume168m/hour30m/hour
2
Applicable Floor Surface~21 m
Cord Length2.5m
Dimensions482mm(W)x142mm(D)x337mm(H)
W eight6.2kg
* The applicable floor surface area is the surface area for when operating the unit in MAX fan level.
(JEM 1467, The Japan Electrical ManufacturersO Association)
Applicable floor surface area indicates the space where a certain amount of dust pollution can be
removed in 30 minutes.
About the reduction of standby power
In order to operate the electrical circuits while the power plug is inserted in the wall outlet, this
product consumes about 1.0W of standby power.
For the conservation of energy, remove the power plug when not using the unit.
E-15 |
ACEC
