Operations available
with remote control
? AUTO operation (fan level)
? MANUAL operation (fan level)
? Pollen mode operation
REMOTE CONTROL OPERATION? OFF timer setting
? DISPLAY ON/OFF
? Cluster ion mode selection
?To start operation, press the POWER ON/OFF button.
A short beep will sound and operation will start in AUTO opera-? AUTO cluster ion mode
tion (fan level).? Clean mode
AUTO cluster ion mode is selected for cluster ion operation.? Ion control mode
?To stop operation, press the POWER ON/OFF button again.? Cluster ion OFF mode
A long beep will sound and operation will stop.
POWER ON/OFF buttonTransmitter
Used to start AUTO opera-Filter reset button
tion (short beep) and stop op-
RESETeration (long beep).Press this button after replacing
the filters.
AUTO (fan level) button
The fan level switches auto-
matically depending on the
amount of pollution in the air.Pollen mode operation button
The unit operates effectively
when you suspect there is pol-
MANUAL (fan level) buttonlen in the air. See Page E-10
The fan level can be switched
between Silent, Medium,OFF timer button
High and Max.Used to set the OFF timer.
PlasmaclusterThe set time switches every time
the button is pressed as shown
DISPLAY ON/OFF button
below.
Switches the Cluster ion
AUTOOFFlamp and CLEAN-SIGN1 hour4 hours
lamp either ON or OFF.
Cancel8 hours
? The cluster ion lamp is
turned on for about 3 sec-
? The remaining time is indicated
onds by pressing the clus-
ter ion select button (ex-by the lamp as time passes.
cluding the OFF button)? The unit will stop operation
when the set time is up.
during ?DISPLAY OFF?
mode.
Cluster ion select button
AUTO cluster ion buttonClean button
The unit will switch between Clean mode andThe unit will constantly operate in
Ion control mode automatically depending onClean mode. Clean mode is effec-
the amount of pollution in the air detected bytive for reducing some airborne
the dust and odor sensors.mold. (Cluster ion lamp on (blue))
?Clean mode? operation is carried out for about
1 minute when operation first starts.
OFF button
Ion control buttonThe generation of ions is stopped
and the cluster ion lamp is turned
The unit will constantly operate in Ion controloff.
mode.
Ion balance is maintained in the room by in-
creasing the ratio of Negative cluster ions.
(Cluster ion lamp on (green))
If the room smells especially moldy, operate the unit in Clean mode.
E-11 |
ACEC
