USING EXTERNAL UNITS
n Mixing from a microphone and a CD
PLAY/PAUSE
FUNCTIONDUBBING To listen to or record mixed signals from an external mi-
VOLUMESPEEDcrophone and CD.
MIX MIC1To protect the speakers from shock noise and to avoid dis-
turbing noises, set the VOLUME control to minimum.
l Be sure that the microphone has a 3.5 mm (1/8") diameter
plug, and is of 600 ohms impedance; if not, use an appro-
priate adaptor.
2Connect the microphone plug to the MIX MIC socket.
3Set the FUNCTION switch to CD.
4Load a compact disc into the CD compartment.
5Press the PLAY/PAUSE button on the CD.
6Adjust the volume of the audio source and the microphone
using the VOLUME control.
RECORDPLAYPLAY
For mixing recording
1Perform steps 1 - 4 above.
n Mixing from a microphone and TAPE
2Load a blank tape into the TAPE 1 cassette compartment.
To listen to or record mixed signals from an external mi-
crophone and TAPE.3Set the DUBBING SPEED switch to NORMAL.
l Mixing recording is not possible if the DUBBING SPEED
1To protect the speakers from shock noise and to avoid dis-switch is set to HIGH.
turbing noises, set the VOLUME control to minimum.
l Be sure that the microphone has a 3.5 mm (1/8") diameter4Press the RECORD button of TAPE 1.
plug, and is of 600 ohms impedance; if not, use an appro-
5Press the PLAY/PAUSE button on the CD.
priate adaptor.
2Connect the microphone plug to the MIX MIC socket.
n Headphones
3Set the FUNCTION switch to TAPE.
l Before plugging in or unplugging the headphones, make
4Load a cassette into the TAPE 1 or TAPE 2 cassette com-sure the volume level is reduced.
partment.l Be sure your headphones have a 3.5 mm (1/8") diameter
plug and are between 16 ohms and 50 ohms impedance.
5Press the PLAY button of the TAPE 1 or TAPE 2.
The recommended impedance is 32 ohms.
6Adjust the volume of the audio source and the microphonel Connect the headphones plug to the PHONES socket. The
using the VOLUME control.speakers will be automatically disconnected. Adjust the
volume by using the VOLUME control.
For mixing recording
1Perform steps 1 - 3 above.
2Load a blank tape into the TAPE 1 cassette compartment.
Insert a prerecorded cassette into the TAPE 2 cassette
compartment.
PHONES3Set the DUBBING SPEED switch to NORMAL.
l Mixing recording is not possible if the DUBBING SPEED
switch is set to HIGH.
4Press the RECORD button of TAPE 1.
5Press the PLAY button of TAPE 2.
Notes:
l Place the microphone about 10-15 cm (4-6") away from
the source.
l If howling occurs, lower the volume or move the microphone
as far as possible from the speakers.
l To record the microphone signals only, load a cassette into
the TAPE 1 cassette compartment, set the FUNCTION
switch to TAPE and the DUBBING SPEED switch to NOR-
MAL. Then, press the RECORD button.
Caution:
l When not using the microphone, remove the microphone
plug from the MIX MIC socket.
E-11 |
ACEC
