Note: Before operating this pre amplifier with the supplied remote control, refer to ?Universal Remote Control? on
page 9 for details about operation.
LISTENING TO A PROGRAM
ENGLISH
Select the desired input source.
TAPE 2 MONITOR
INPUT SELECTOR
Before operation
1
enter the standby mode.
POWER
ON/OFF
or
The STANDBY button lights up in red. This
means that the unit is connected to the AC outletCDP L A Y E R
and a small amonut of current is retained to
DT S(pOt )
support the memorized contents and operation
readiness.SURROUND mode Input sourceDIGITAL or ANALOG input
To switch the power off, push the POWER switchEach time the INPUT SELECTOR knob is rotated, the input
again.source changes as follows:
PHONO TUNER CD PLAYER TAPE 1 DVD PLAYER
Then the power is cut off and the STANDBY
(frequency display)
button goes off.
AUX/TV VIDEO3 VIDEO2 VIDEO1 LD PLAYER
In the standby mode, to turn the power on.
Each time the VCR1 button on the remote control is pressed,
STANDBYthe input source changes as follows:
orVIDEO 1 VIDEO 2 VIDEO 3
When the TAPE 2 MONITOR button is set to on and TAPE
2 MONITOR button on the front panel lights up in green,
orother inputs can not be heard from the speakers.
To listen to a input source other than TAPE 2 MONITOR, be
sure to set the TAPE 2MONITOR button to off.
TAPE 2 MONITOR function
You can connect either a tape deck or a graphic
equalizer to the unit?s TAPE 2 MONITOR jacks.
When listening to the component connected to
The STANDBY button lights up in green and the
these jacks,set the TAPE 2 MONITOR button to on.
unit is turned on and enters the operating mode.
If you connect a 3-head tape deck, you can listen to the
In the standby mode, if the INPUT SELECTORsound being recorded during recording, instead of the
button is pressed on the remote control, the unit issource sound.
turned on automatically and the desired input isFor further details, refer to the operating instructions
of the component connected.
selected.
When selecting the 6-CH DIRECT inputs as desired.
In the operating mode, to enter the standby mode.
6-CH DIRECT
6-CH DIRECT
STANDBY
The 6 separate analog signals from 6-CH decoder connected to
this unit pass through the tone(bass,treble) and volume circuits
only and directly transfer to the LINE OUTS of this unit.(In
or
case that the TAPE 2 MONITOR button is set to on, the TAPE
2 MONITOR button is automatically set to off.)
Press the 6-CH DIRECT button again to cancel the 6-CH
direct function.
These 6 separate analog signals can be heard only, not
The STANDBY button lights up in red.recorded.
13 |
ACEC
