ENGLISH
THE P2T TRANSMIXER
Controls and Features
1245
FRONT PANEL:
6
3
BACK PANEL:
789
1. MIC/LINE INPUT Jacks: Electronically balanced inputs5. SELECT Button: Press to select a frequency channel.
1
that accommodate both XLR and /4-inch connectors at6. Antenna: Permanently mounted, break-resistant anten-
mic or line levels.
na transmits the mix to the P2R Receiver.
2. Signal/Clip LEDs: Color indicates the signal status of the7. Power Cord Strain Relief: Thread the power cable
corresponding MIC/LINE input, as explained in the Audiothrough these slots to secure the DC connection.
Inputs and Outputs section below.
8. DC IN: Plug the power supply into this connector. The unit
3. INPUT Knobs: Control the level of their corresponding remains powered on until you unplug it.
inputs.
9. SPLIT OUTs: Each male XLR output jack duplicates the
4. CHANNEL LED Indicator: Displays the frequency chan-signal of the corresponding mic/line input. Front panel set-
nel that is being transmitted (1-8).tings have no effect on split output level.
Audio Inputs and Outputs
The INPUT knobs control both MIC and LINE level signals. As a general guide-INPUT LED
line, set the knob to the left of twelve o?clock for line level signals, and to the rightRED? Limited Signal*
of twelve o?clock for microphone levels.YELLOW? Nominal Level
Observe the signal/clip LEDs. If they are consistently red, decrease the levelGREEN? Signal Present
with the corresponding INPUT knob.
NOTE: If the level is decreased all the way and the LED
Microphone
remains red, the level of the input from the previous device LineLevel
Level
in the audio chain (mixer, click track, digital sequencer, etc.)
INPUT Knob
is too high and should be decreased.
To pass audio signal directly through the TransMixer, use the corresponding SPLIT OUT on the rear panel of the device. Input settings
do not affect the level of the signal at the SPLIT OUT connectors.
* The P2T inputs have limiting circuitry that activates automatically when the input level is too high.
Phantom Power
Although the TransMixer itself does not provide phantom power for condenser microphones, the SPLIT OUT connectors pass phantom pow-
er from a phantom power supply to a microphone connected to the corresponding input jack. You can connect equipment that supplies phan-
tom power to the TransMixer without harming the unit.
CAUTION!: Use a ?direct box? when connecting guitars, keyboards, and other instruments to a mixing console through the P2T.
The phantom power that mixing consoles provide for microphones can damage other instruments. Connect the instrument to the
direct box then connect the direct box to the TransMixer input.
Selecting a Frequency Channel
1. Press and hold the SELECT button until the CHANNEL LED indicator begins to flash.
2. When the LED indicator is flashing, press the SELECT button to scroll to the desired frequency channel.
3. Release the button. After 4 seconds the display will stop flashing and the P2T will automatically switch to the
specified channel.
IMPORTANT:
Never set more than ONE TransMixer to the same frequency channel, or interference will occur.
6 |
ACEC
