Additional Information
Sound
Troubleshooting
There is no sound.
, The connecting cord is not connected
If you experience any of the following
securely.
difficulties while using the receiver, use this
, The connecting cord is damaged.
troubleshooting guide to help remedy the
, Press MUTING on the remote if OMUTING
problem before requesting repairs. Should
ON � is displayed on the front panel display.
any problem persist, consult your nearest
, The protective device on the receiver has
Sony dealer.
been activated because of a short circuit. Turn
off the receiver, eliminate the short-circuit
Powerproblem and turn on the power again.
, The audio connecting cord is damaged.
The power is not turned on.
Replace it with a new one.
, Check that the AC power cord (mains lead) is
, The receiver is in pause mode or in Slow-
connected securely.
motion Play mode. Press H to return to
normal play mode.
Picture, Fast forward or fast reverse is performed.
Press H to return to normal play mode.
There is no picture., Check the speaker settings (pages 23, 68).
, The connecting cords are not connected
securely.
The left and right sounds are
, The connecting cords are damaged.
unbalanced or reversed.
, The receiver is not connected to the correct
, Check that the speakers and components are
TV input jack (page 21).
connected correctly and securely.
, The video input on the TV is not set so that
, Adjust the front balance parameter in the
you can view pictures from the receiver.
LEVEL menu (pages 26, 70).
Picture noise appears.
Severe hum or noise is heard.
, The disc is dirty or flawed.
, Check that the speakers and components are
, If the picture output from your receiver goes
connected securely.
through your VCR to get to your TV, the
, Check that the connecting cords are away
copy-protection signal applied to some DVD
from a transformer or motor, and at least
programmes could affect picture quality.
3 meters (10 feet) away from a TV set or
fluorescent light.
Even though you set the aspect ratio
, Move your TV away from the audio
in OTV TYPE� of OSCREEN SETUP,�components.
the picture does not fill the screen., The plugs and jacks are dirty. Wipe them with
, The aspect ratio of the disc is fixed on ya cloth slightly moistened with alcohol.our
DVD., Clean the disc.
The picture is black and white.The sound loses stereo effect when
, Depending on the TV, the picture on theyou play a VIDEO CD, or a CD.
screen becomes black and white when you, Set OAUDIO � to OSTEREO� in the Control
play a disc recorded in the NTSC colourMenu display (page 44).
system., Make sure you connect the receiver
appropriately.
GB
72 |
ACEC
