DFS-700/700P
Executing an Effect
To execute an effect, after setting the execution direction (normal/reverse),Using the AUTO TRANS button
in the effect transition section press the AUTO TRANS button, or move
the fader lever.To execute the effect automatically at the preset transition time, press the
AUTO TRANS button, turning it on.
12TITLEDSKEDGEUSER PGMSNAP SHOT
EDITORLUMLUMLUMSHADOWTRAILSTATUS EDITTo pause the transition
GPICRKCRKBORDERBEVELDEDGE INITIALEDITLEARNDuring the transition, press the AUTO TRANS button, turning it off.
SET UPMASKMASKMASKSOFTRECALL
SHIFTCCR LIGHTINGMATTESBORDER PATTERNADJ PAGEF1F2F3F4F5HOLDEFFECTINPUTLOCATIONNote
TRANS RATEDSKFTBSETPATTERN NUMBERSETIf the fader lever is in an intermediate position, then the transition pauses
AUXILIARYSOURCE SOURCEFILLLAST XFADECCRTITLE 1 TITLE 2 DSKSUPER BGFRGD 2MEMORYFRAME FREEZMIXEFFECTN/RREVDIRECTRECALLPATTERNDIRECTDSK PVWat the corresponding position. To make sure the transition does not pause,
TO
BLACK12345678MEMORYINTVIDEOTITLE789INSBACKGROUNDBLACKfirst move the fader lever to either end of its travel.
BLACK12345678MEMORYVIDEOINTCUTP IN P456DEL
123RSTFOREGROUNDDSK
BLACK12345678MEMORYVIDEOINTTRANSAUTO0DOWNUPENTERPATTERN/KEY PADTo resume the transition
Press the AUTO TRANS button again.
Fader lever
Chapter 3 Basic OperationChapter 3 Basic Operation
AUTO TRANS buttonUsing the fader lever and AUTO TRANS button together
You can use the AUTO TRANS button to complete a transition started and
paused with the fader lever, or in the opposite way, use the fader lever to
complete a transition started and paused with the AUTO TRANS button.
Using the fader leverYIf you resume a transition partially executed with the fader lever, using
the AUTO TRANS button, then the transition time taken is in proportion
By moving the fader lever from one end of its travel to the other at anyto the setting for the entire transition. For example, if the transition time
desired speed, you can manually control the transition.is set to 100 frames, and you carry out the equivalent of 25 frames with
The transition indicator on the left of the fader lever lights progressivelythe fader lever, then press the AUTO TRANS button, the remainder of
corresponding to the status of the transition. When the transitionthe transition will take 75 frames.
completes, the transition indicator goes completely off.YIf you partially execute the transition with the AUTO TRANS button,
For an effect in which the image switches like a cut, the transition occursthen start moving the fader lever, the transition resumes when the fader
when the fader lever is in the center position.lever reaches the corresponding intermediate position.
NoteNote
After powering on the system, move the fader lever once through theWhen you carry out an auto transition by controlling the processor unit
whole of its travel. This will ensure that the fader lever operates correctly.from an external editor through the EDITOR connector, then regardless of
the fader lever position, the transition is executed in its entirety.
To pause the transition
Stop moving the fader lever.
To resume the transition
Start moving the fader lever again.
1-41
3-54Chapter 3 Basic OperationChapter 3 Basic Operation3-55 |
ACEC
