1-54
User Program Effects
7When you have deleted all the desired key frames, press the EDITCopying a key frame
button.
You can use the temporary assignment function to copy data from one key
The button goes off, and the user program effect is resaved without the
frame to another.
deleted key frames.Use the following procedure.
1Recall the user program effect you want to copy from, and press the
Temporarily saving key frame data (temporary assignment function)
EDIT button, turning it on.
While editing user program effects, you can temporarily assign key frame
For details see OTo recall a user program effect� (page 4-12).
data to keypad numeric buttons. This makes it easy to recall the data for
use in changing or adding key frames. You can save 10 sets of data each2Press the UP or DOWN button in the pattern/numeric keypad until the
for linear and nonlinear effects, for a total of 20 key frames.number of the key frame you want to copy from appears in the EDIT
display window.
To save key frame data
Use the following procedure.3Display page 3/3 of the menu.
1Press the EDIT button to switch to user program edit mode.
4Hold down the F1(CpTo+) button, and press a numeric button in the
pattern/numeric keypad.
2Adjust the parameters in the menu, to create the key frame.
The indication for the selected number in the menu changes from O��
3Display page 3/3 of the menu.to O*�, and this saves the key frame temporarily.
4Hold down the F1(CpTo+) button, and press a numeric button in the
5Press the EDIT button, turning it off, and exit user program edit mode.
Chapter 4 Advanced Operationspattern/numeric keypad.Chapter 4 Advanced Operations
6Recall the user program effect to which you want to copy, and press
The indication for the selected number in the menu changes from O��the EDIT button, turning it on.
to O*�, and this saves the key frame temporarily.
Note
To recall a key frame
The copy destination must be a user program effect of the same type
Use the following procedure.
(linear or nonlinear) as the copy source.
1Press the EDIT button to switch to user program edit mode.7Press the UP or DOWN button in the pattern/numeric keypad, until the
number of the key frame you want to copy to appears in the EDIT
2Display page 3/3 of the menu.display window.
3Hold down the F2(CpFrm+) button, and press a numeric button in the8In page 3/3 of the menu, hold down the F2(CpFrm+) button, and press
pattern/numeric keypad.the numeric button in which you saved the key frame in step 4.
This recalls the temporarily saved key frame.
9Press the ENTER button.
NotesThis copies the key frame data to the destination.
Y You cannot use a linear key frame in a nonlinear effect, nor a nonlinear
10When the copy is completed, press the EDIT button, turning it off.
key frame in a linear effect.
Y The key frames temporarily saved in numeric buttons are lost when the
DFS-700/700P is powered off.
DFS-700/700P
4-16Chapter 4 Advanced OperationsChapter 4 Advanced Operations4-17 |
ACEC
