Learning the Remote Code for a Connected Component � LEARN Mode
You can add new remote codes using EXPAND CODE.Notes
Y When the remote code is successfully learned, a O*� will
appear next to the remote code name.
Adding a new remote key - EXPAND CODEY You can add up to 31 additional remote codes for each
source component, and up to 10 for each common
components.
1Press MODE repeatedly until ?<<LEARN>>Tt?
Setting up the Main UnitY You must complete step 5 within one minute after the
appears in the display window, then press ENTER.
remote code name is displayed in the display window;
OWHICH MENU?� appears for a few seconds.
otherwise, your entry will not be learned and OLEARN
2Press the R cursor or r cursor to select ?EXPANDFAILED!� appears.
CODE?, then press ENTER.
6Repeat step 5 to enter other remote codes.
OCONNECT TO?� appears for a few seconds.
7Press ENTER when you have finished.
3Press the R cursor or r cursor repeatedly to select
OSETTING NOW�� appears for a few seconds.
the desired component.
The display window returns to the NORMAL mode.
Each time you press the R cursor or r cursor, the
display window changes cyclically as shown below.Notes
Y Even if you quit the LEARN mode in the midst of making
CONNECT TO? (Appears for a few seconds)the settings, the remote codes that have already been
rlearned will be stored.
t SOURCE1R rY Some remote codes cannot be learned. In this case,
OMEMORY FULL� appears, then the display window
returns to the previous remote code entry. The remote
SOURCE8R r
codes that have previously been learned will be stored.
COMMON 1R r
��
t COMMON 10R r
Note
A component that has not been connected to the Main Unit is
grayed out in the display window. You cannot select it.
4Press ENTER.
OINPUT IR CODE� appears for a few seconds, then
the display window changes to OCODE ID #81R r�
when you select SOURCE in step 3, and changes to
OCODE ID #110R r� when you select COMMON.
5While the code ID number is displayed in the
display window, press the corresponding button
on the remote control of the component while
pointing it toward the learning IR window of the
Main Unit.
When your entries are confirmed, OCOMPLETED!�
appears for a few seconds, then the display window
moves to the next remote code entry.
If your entries are not confirmed, OLEARN FAILED!�
appears for a few seconds, then the failed code ID
number appears.
Tips
Y When you want to skip the code ID number, press the r
cursor.
Y When you want to re-enter the code ID, press the R cursor.
US
22 |
ACEC
