Setup 4: Bundle the cords and Setup 5: Turn on the monitor and
cablescomputer
1 Slide up the back cover.1 Press the MAIN POWER switch located on the right
side of the monitor in the direction of the [, if it is not
2 Secure the video signal cable, audio cords and the already pressed. Make sure the 1 (power) indicator
power cord using the cable holder on the cabinet.is lit in red.
3 Slide down the back cover.Note
The monitor is factory shipped with the MAIN POWER switch set
to on ([).
4 Bundle all the cords and cables through the cable
holder of the stand.
13
lights in red
back cover
MAIN POWER
2
2Press the 1 (power) switch on the front right of the
monitor.
GB
The 1 (power) indicator lights up in green.
SDM-X93 only
lights in green
4
3 Turn on the computer.
4 Press the INPUT button to select the desired input
Note
signal.
If you cannot bundle all the cords and cables through the cable holder of
The selected input?s picture appears on the screen.
the stand, leave them hanging down.
For more information, see ?Selecting the input signal (INPUT
button)? on page 11.
INPUT
The installation of your monitor is complete. If necessary, use the
monitor?s controls to adjust the picture (page 12).
(continued)
9 |
ACEC
