WARNINGOwnerOs Record
The model and serial numbers are located at the rear
To prevent fire or shock hazard, do notof the unit.
expose the unit to rain or moisture.Record the serial number in the space provided
below. Refer to them whenever you call upon your
To avoid electrical shock, do not open the cabinet.Sony dealer regarding this product.
Refer servicing to qualified personnel only.
Model No.
For the customers in the United States
Serial No.
Except for customers in the United
States
This appliance is classified as a CLASS 1 LASER
product.
The CLASS 1 LASER PRODUCT MARKING is
located on the rear exterior.
This symbol is intended to alert the user to
the presence of uninsulated dangerous
voltage within the products enclosure
that may be of sufficient magnitude to
AC power cord must be changed only at the qualified
constitute a risk of electric shock to
service shop.
persons.
Do not install the appliance in a confined space, such
as a bookcase or built-in cabinet.
This symbol is intended to alert the user to
the presence of important operating and
To prevent fire, do not Cover the ventilation of the
maintenance (servicing) instructions in theapparatus with news papers, table-cloths, curtains,
literature accompanying the appliance.etc. And dont place lighted candles on the apparatus.
To prevent fire or shock hazard, do not place vases on
INFORMATIONthe appartus.
This equipment has been tested and found to comply
Dont throw a battery, dispose it as
with the limits for a Class B digital device, pursuant
the injurious wastes.
to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radioThis Class A digital apparatus complies with
frequency energy and, if not installed and used in
Canadian ICES-003.
accordance with the instructions, may cause harmful
interference to radio communications. However, thereCAUTION
is no guarantee that interference will not occur in aTO PREVENT ELECTRIC SHOCK, DO NOT USE
particular installation. If this equipment does causeTHIS POLARIZED AC PLUG WITH AN
harmful interference to radio or television reception,EXTENSION CORD, RECEPTACLE OR OTHER
which can be determined by turning the equipmentOUTLET UNLESS THE BLADES CAN BE FULLY
off and on, the user is encouraged to try to correct theINSERTED TO PREVENT BLADE EXPOSURE.
interference by one or more of the following
measures:
� Reorient or relocate the receiving antenna.About this manual
� Increase the separation between the equipment and
receiver.
The instructions in this manual are for CDP-XE570,
� Connect the equipment into an outlet on a circuit
CDP-XE370, and CDP-XE270. CDP-XE570 is the
different from that to which the receiver is
connected.model used for illustration purposes only. Any
� Consult the dealer or an experienced radio/TVdifference in operation is clearly indicated in the text,
technician for help.for example, CDP-XE570 only.
CAUTIONTip
You are cautioned that any changes or modificationInstructions in this manual describe the controls on
not expressly approved in this manual could voidthe player.
your authority to operate this equipment.You can also use the controls on the remote if they
have the same or similar names as those on the player
2
(CDP-XE570/XE370 only). |
ACEC
