2-1 Control Panels
4 VIDEO knob and PRESET/MANUAL switch7 CHROMA (chrominance) PHASE knob and
The switch makes the selection described immediatelyPRESET/MANUAL switch
below. When it is set to MANUAL, you can use theThe switch makes the selection described immediately
knob to adjust the video signal output level.below. When it is set to MANUAL, you can use the
PRESET: Regardless of the position of the knob, theknob to adjust the chrominance phase (the phase
video signal output level is set to the referencedifference from a burst signal).
value.PRESET: Regardless of the position of the knob, the
Chapter 2Location and Function of Parts
MANUAL: You can adjust the video signal outputchrominance phase is set to the reference value.
level in the range ?3 dB.MANUAL: You can adjust the chrominance phase in
You can change the adjustment range usingthe range ?30u.
extended menu item 714.
8 SYNC knob
5 CHROMA (chrominance) knob and PRESET/This adjusts the output signal sync phase with respect
MANUAL switchto the input reference signal to this unit, in a range of
The switch makes the selection described immediately?15 ms.
below. When it is set to MANUAL, you can use theUse this adjustment when the output phase of this unit
knob to adjust the chrominance signal output level.is not accurately aligned with the reference signal
PRESET: Regardless of the position of the knob, thephase, or when carrying out special effects editing with
chrominance signal output level is set to thethis unit and other VTRs connected to a switcher or
reference value.other equipment.
MANUAL: You can adjust the chrominance signal
output level in the range ?3 dB.9 SC (subcarrier) knob
You can change the adjustment range usingThis adjusts the output signal subcarrier phase with
extended menu item 714.respect to the input reference signal to this unit, in a
range of ?200 ns.
6 SET UP (DNW-65)/BLACK LEVEL (DNW-For playback of composite signals, use this adjustment
65P) knob and PRESET/MANUAL switchwhen the output phase of this unit with respect to the
The switch makes the selection described immediatelyphase of the reference signal is not accurately aligned
below. When it is set to MANUAL, you can use thewith the subcarrier phase. This adjustment does not
knob to adjust the (black) setup level (525/60 system)affect the output SCH (subcarrier - sync) phase, which
or black level (625/50 system).remains constant.
PRESET: Regardless of the position of the knob, the
!1 GOOD SHOT switch
setup level (525/60 system) or black level (625/50
When this switch is in the REC INHIBIT position, the
system) is set to the reference value.
GOOD SHOT REC INHIBIT indicator in the lower
MANUAL: You can adjust the setup level (525/60
1)control panel lights, and recording shot marks on tape
system) in the range ?30 IRE, or the black level
is no longer possible.
(625/50 system) in the range ?210 mV.
!� KEY INHIBIT switch
When this switch is in the ON position, the KEY
INHIBIT indicator in the lower control panel lights,
and the buttons in the upper control panel and lower
control panel specified by the setting of extended
menu item 118 are disabled.
..........................................................................................................................................................................................................
1) IRE: A unit for representing a video level laid down by
the IRE (Institute of Radio Engineers). The IRE is now
the IEEE (Institute of Electrical and Electronic
Engineers).
2-12Chapter 2Location and Function of Parts |
ACEC
