2-2-14. L Motor Assembly, Motor Shield, FP-248 Flexible Board, TG1 Spring Hook, Spring Hook Fulcrum Base,
Spring Hook Driving Arm, Worm Shaft, Deceleration Gear and Motor Holder
Removing method
Y Refer to the detailed diagram on the right, and remove each part.
Removal of TG1 spring hook
L motor assembly
Rotate to the left slightly opened.
Motor shieldUnhooks.
TG1 spring hook
Spring hook
fulcrum baseFP-248 flexible board
(DEW sensor)
Two claws (L motor)
Does not disconnect.Disconnects here.
Spring hook
Two claws (motor shield)
driving arm
Removal of motor shield and worm shaft
Motor holder
2Motor shield
Claw
1
Worm shaft
Claw
1
Motor shield
2
Claw
Deceleration gear
Motor holder
Motor holder
(Top side)
(Bottom side)
Attaching method
1. Attach the worm shaft.3. Attach the TG1 spring hook to the spring hook fulcrum base.
Worm shaft
Rotate to the right slightly opened.
Hook the hook.
Insert1
2Claw (Insert)
Motor holder (Bottom side)
2. Attach the L motor assembly, motor shield and deceleraAttach at this position.tionDoes not disconnect.
gear.
4. Attach the spring hook driving arm and spring hook fulcrum
L motor assemblybase.
Spring hook
Claw
fulcrum base
Claw
Positioning hole.Motor holderSpring hook Phase
driving arm
adjustment
Claw
Claw
Deceleration
2
gear
5. Grease the part.
Motor shield
1Positioning boss.
Claw
L motor block assembly
(Bottom side)
Motor holder (Top side)
Apply the grease
(1.5mm dia.)
5-49 |
ACEC
