Additional Information
, Even if your TV is compatible with
Troubleshootingprogressive format (480p) signals, the image
may be affected when you set
?COMPONENT OUT ? to?PR OGRESSIVE.?
If you experience any of the following
difficulties while using the player, use this In this cas?eC,O sMPONEet NT OUT ? to
?INTERLACE.?
troubleshooting guide to help remedy the
problem before requesting repairs. Should
any problem persist, consult your neEvaen resthougt h you set the aspect ratio
Sony dealer.in ?TV TYPE? of ?SCREEN SETUP, ?
the picture does not fill the screen.
Power, The aspect ratio of the disc is fixed on your
DVD.
The power is not turned on.
, Check that the AC power cord is connected Sound
securely.
There is no sound.
Picture, The connecting cord is not connected securely.
, The connecting cord is damaged.
There is no picture., The player is connected to the wrong input
, The connecting cords are not connected jack on the amplifier (receiver) (page 22, 23,
securely.24).
, The connecting cords are damaged., The amplifier (receiver) input is not correctly
, The player is not connected to the corrseectt TtoV th e player.
input jack (page 18)., The player is in pause mode or in Slow-motion
, The video input on the TV is not correctpllyay m seotd.e.
, The player is in fast forward or fast reverse
mode.
Picture noise appears., If the audio signal does not come through the
, The disc is dirty or flawed.DIGITAL OUT (OPTICAL or COAXIAL)
, If the picture output from your player gojackess , check the audio settings (page 75).
through your VCR to get to your TV, the copy-
protection signal applied to some DVD
programs could affect picture qualitSoy.und is If you noisy.
still experience problems even when ,you The disc is dirty or flawed.
connect your player directly to your T, VWhe, n playing a CD with DTS sound tracks,
please try connecting your pla?ys er to younoir TseV will come from the LINE OUT L/R
S video input (page 18).(AUDIO) 1/2 jacks (page 30).
, You have sele?ctPRedOG RESSIVE? in
?COMPONENT OUT ? even though your TV Sound distortion occurs.
cannot accept the signal in progressive format.
In this case, set the VIDEO OUT SCAN , Set? AUDIO ATT? in?AUD IO SETUP? to
?ON ? (page 74).
SELECT switch on the back panel of the
player to INTERLACE. Then set
?COMPONENT OUT ? to?IN TERLACE?
after you can see the TV screen correctly and
reset VIDEO OUT SCAN SELECT to
SELECTABLE.
76 |
ACEC
