2Press the FRAME button to enter into the5Repeat pressing the DETECT button to
detection frame setting mode.select a frame to be used.
Each time that button is pressed, the frame to
be used is cyclically changed as follows:MD MODEFRAME DRIVE
SET FRAME
FRAME 1FRAME 2F1 & F2*
MD MODEFRAME DRIVE
SET FRAME
FRAME 1
3Decide the position and size of the
FRAME 1.F1&F2
q Press the arrow button to set the position*If a change is detected even in either of FRAME 1
of the FRAME 1. Then press the FRAMEor FRAME 2, the lamp at the side of the lens lights
button.up red.
MD MODEFRAME DRIVE
6Press the START/STOP button toSET FRAME
activate the MD function.
MD MODE
WORKING NOW
FRAME 1
w Press the arrow button to set the size of the
FRAME 1. Then press the FRAME
button.FRAME 1
MD MODEFRAME DRIVE
SET FRAME
To turn off the setting value and/or
frame
If the setting value and/or frame are displayed as
you record a picture, those come with the recorded
FRAME 1
picture.
To turn off the setting value, press the DATA
That completes the settings of the FRAME 1Os
SCREEN button.
position and size, and enter into the setting
To turn off the frame, press the FRAME
mode of the FRAME 2.
DISPLAY button.
If you choose not to set the FRAME 2,
proceed with the step 5.
To cancel the MD function
Press the START/STOP button.
4Repeat the procedure of the step 3 to setTo exit from the MD mode, press the MD ON/
OFF button.
the FRAME 2Os position and size.
Note
Once the frame is set, it remains memorized until the
power is turned off.
To retain the memory of the frame setting even if the power
is turned off, set the BACKUP switch, at the rear of the
camera head, to ON. (See OAbout backup� on page 25.)
continue to next pageEN
19 |
ACEC
