Getting Started
This monitor will sync with any IBM or compatible systemStep 2: With the monitor switched off, attach the power
equipped with VGA or greater graphics capability.cord to the monitor and the other end to the power
Although this monitor will sync to other platforms,outlet.
including Macintosh and Power Macintosh system, a cable
adapter is required. Please consult your dealer for advice on
Power cord (supplied)
which adapter is suitable for your needs.
to a wall outlet
Step 1: With the computer switched off, attach the video
signal cable to the monitor (HD15/5 BNCOs) and
attach the other end to the video card.
Step 3: Turn on the monitor and computer.
Step 4: Switch the input connector according to the
adjustment procedure on page 10.
Step 5: If necessary, adjust the user controls according to
to HD15your personal preference.
IBM or Compatible ComputerThe installation of your monitor is complete. Enjoy your
monitor.
to video outputVideo signal cable
Notice
(supplied)
Apple ComputerTo comply with the limits of FCC Class B and IC Class B for
to video output
digital device, please attach the supplied video signal cable
for HD15 input or SMF-400 (sold separately) for BNC input.
Macintosh AdapterFurthermore, each cable has ferrite cores on it.
(supplied)
to
VIDEO IN R/G/B
IBM or Compatible ComputerSYNC IN HD/VD
Video signal cable
to video output
(not supplied)
Apple Computer
to video output
Macintosh Adapter
(supplied)
Note : Use HD15 (Female)-HD15(Male without No.9 pin)
adapter (supplied) for current DOS computer which
has no compliance of DDC 2AB and its No.9 pin is
disconnected.
4 |