Getting StartedGetting Started
Automatically Adjusting the Size
Step 2: Connect the power cord
and Centering of the Picture
With the monitor switched off, connect one end of the
By pressing the auto sizing and centering (ASC) button, the
power cord to the monitor and the other end to a power
size and centering of the picture are automatically adjusted
outlet.
to fit the screen.
to a power outletto AC IN
1Turn on the monitor and computer.
Power cord (supplied)
2Press the ASC button.
The picture is adjusted to fit the center of the screen.
ASC
Step 3: Turn on the monitor and computer
The installation of your monitor is complete.
Note
If OOUT OF SCAN RANGE� or ONO INPUT SIGNAL� appears on
the screen, see OWarning Messages� on page 20.Notes
EN
Y This function is intended for use with a computer running
For customers using Windows 95/98Windows or similar graphic user interface software that
To maximize the potential of your monitor, install the new modelprovides a full-screen picture. It may not work properly if theF
information file from the supplied Windows Monitor Informationbackground color is dark or if the input picture does not fill the
Disk onto your PC.screen to the edges (such as an MS-DOS prompt).
ES
This monitor complies with the OVESA DDC� Plug & PlayY The screen may go blank for a few seconds while performing the
standard. If your PC/graphics board complies with DDC, selectauto-sizing function. This is not a malfunction.
C
OPlug & Play Monitor (VESA DDC)� or this monitorOs model nameY Although the signals for picture aspect ratio 5:4 (resolution: 1280
as the monitor type in the OControl Panel� of Windows 95/98.´ 1024) do not fill the screen to the edges, the picture is
If your PC/graphics board has difficulty communicating with thisaccurately displayed.
monitor, load the Windows Monitor Information Disk and select
this monitorOs model name as the monitor type.
For customers using Windows NT4.0
Selecting the On-screen Display
Monitor setup in Windows NT4.0 is different from Windows 95/98
and does not involve the selection of monitor type. Refer to theLanguage
Windows NT4.0 instruction manual for further details on adjusting
the resolution, refresh rate, and number of colors.If you need to change the OSD language, see OUsing the
LANG (Language) On-screen Display� on page 17.
The default setting is English.
7 |
ACEC
