Connections
Before using this monitor, check that the following itemsConnecting to the 5 BNCOs connector
are included in your package:
Y Monitor (1)
Y Video signal cable (1)
Y Power cord (1)
1)
Y Macintosh adapter (1)
Y HD15 (Female) �HD15 (Male without the No. 9 pin)
adapter (1)
to VIDEO IN R/G/Bto SYNC IN HD/VD
Y Warranty card (1)
Y This operating instructions (1)
This monitor will sync with any IBM or compatible systemVideo signal cable SMF-
2)400 (not supplied)
equipped with VGA or greater graphics capability.
Although this monitor will sync with other platforms, a
cable adapter is required. Please consult your dealer for
Connect to the computer in the same
advice on which adapter is suitable for your needs.
way as for the HD15 connector.
Step 1: Connect the monitor to the
For the customers using IBM PC or IBM compatible
computer.
system which is not compatible with DDC2AB and
With the computer switched off, connect the video signalDDC2B+
cable to the monitor (HD15/5 BNCOs) and connect the otherThis monitor uses a No. 9 pin in the video signal connector for
end to the video output.DDC2AB and DDC2B+ compatibility.
Some PC systems which are not compatible with either DDC2AB or
To connect the HD15 connector, use the supplied video
DDC2B+ may not accept the No. 9 pin. If you are not sure whether
signal cable.
your PC system accepts the No. 9 pin or not, use the HD15 (Female)
To connect the 5 BNCOs connector, use the SMF-400 video
- HD15 (Male without the No. 9 pin) adapter (supplied). Make sure
signal cable (not supplied).
that the male side (without the No. 9 pin) is connected to the
computer.
Note
Do not touch the pins of the video signal cable.For the customers using the Macintosh computer
Supplied Macintosh adapter is compatible with Macintosh LC,
Connecting to the HD15 connector
Performa, Quadra and Power macintosh series computers.
Macintosh II series and some older version of PowerBook models
may need an adapter with micro switches.
Step 2: Connect the power cord.
With the monitor switched off, connect the power cord to
the monitor and the other end to the power outlet.
to HD15
to a wall outlet
IBM or compatible
to video outputPower cord (supplied)
computer
Video signal
cable
(supplied)
HD15�HD15 adapter
The installation of your monitor is complete. Enjoy your
(supplied) *
monitor.
Macintosh computer
to video output
Notice
To comply with the limits of FCC class B and IC Class B for digital
Macintosh adapterdevice, please attach supplied video signal cable for HD15 input or
(supplied)SMF-400 (not supplied) for BNC input. Furthermore, each cable
must have ferrite cores in it.
* The HD15�HD15 adapter may be needed for some models.
1) Macintosh and Power Macintosh are trademarks of Apple
Computer Inc.
2) VGA is a trademark of IBM Corporation.
4 |
ACEC
