2-1 Control Panels
2-1-3 Switch Panel
To access the switch panel, open the lower controlOn how to open the lower control panel, see the figure on
panel.page 2-1.
Chapter 2Location and Function of Parts
1 KEY INHIBIT switch
2 PANEL SELECT switch
3 CONTROL PANEL connector
KEY INHIBITPANEL SELECTCONTROL PANEL
ONOFFREARFRONT
4 Memory card ejection button
5 Memory card slot
1 KEY INHIBIT switch4 Memory card ejection button
Moving this switch to the ON position disables thePress to eject a memory card from the memory card
controls on the upper and lower control panels.slot.
You can specify which buttons and knobs are disabled
in setup menu item 118.5 Memory card slot
Insert a memory card to update this unitOs firmware.
2 PANEL SELECT switchYou can save or load setup menu settings onto the
In addition to the lower control panel, you can connectmemory card.
a similar control panel to this unit. When two control
panels are connected to the unit, the PANEL SELECTFor details on firmware update and setup menu reading/
switch is used to specify which panel be enabled tostoring, refer to the Maintenance Manual Volume 1.
control the unit.
FRONT: Enables the control panel connected to the
CONTROL PANEL connector on the switch
panel.
REAR: Enables the control panel connected to the
CONTROL PANEL connector on the connector
panel. When setup menu item 117 is set to PARA,
this switch position also enables the control panel
connected to the CONTROL PANEL connector
on the switch panel.
3 CONTROL PANEL connector (10-pin, round
type)
Plug in the lower control panel connection cable.
2-14Chapter 2Location and Function of Parts |