Doing a tape search in the reverse direction at aDoing a tape search in the forward direction at a
specified speedspecified speed
Hold down this button while the VTR is rewinding theHold down this button while the VTR is fast-
tape. The tape is searched as it is being rewound at theforwarding the tape. The tape is searched as it is being
speed specified by SEARCH in the VTR CONTROLfast-forwarded at the speed specified by SEARCH in
menu (2�, 5�, or 8� normal playing speed) (see pagethe VTR CONTROL menu (2�, 5�, or 8� normal
7-5). The indicator flashes during the searchplaying speed) (see page 7-5). The indicator flashes
Chapter 2
operation.during the search operation.
Changing the search speed during a reverse-searchChanging the search speed during a forward-
Location and Function of Parts
of the tapesearch of the tape
Press this button while holding down the FUNCPress this button while holding down the FUNC
button. Each time you press the REW 0 button, thebutton. Each press of the F FWD ) button changes
search speed changes from the current speed to thethe search speed (2�, 5�, or 8� normal playing speed),
next one in sequence (2�, 5�, or 8� normal playingregardless of the SEARCH setting in the VTR
speed), regardless of the SEARCH setting in the VTRCONTROL menu.
CONTROL menu.
Changing to still-picture mode
Changing to still-picture modePress this button and REW 0 button simultaneously.
Press this button and F FWD ) buttonWhen you release either of the buttons, the VTR
simultaneously. When you release either of thesearches the tape at normal playing speed in the
buttons, the VTR searches the tape at normal playingdirection indicated by the button that is still being
speed in the direction indicated by the button that ispressed. When you release both buttons, the VTR
still being pressed. When you release both buttons, thestops.
VTR stops.
8 FUNC (function) button and indicator
7 F FWD ) (fast-forward) button and indicatorPress this button while the tape is stopped, or during
The function of this button varies according to thefast-forwarding or rewinding to monitor the E-E
1)
VTR status and the button with which it issignal output from the ANALOG HD COMPONENT
simultaneously pressed.MONITOR OUT connector and the COMPOSITE
MONITOR OUT connector (see page 2-15). If you
Fast-forwarding the tapepress the button with no cassette loaded, the VTR
2)
Press this button to fast-forward the tape. Theenters E-E mode. Note that E-E signal monitoring is
indicator flashes as the tape is fast-forwarding, andpossible only when V TEST SG in the SYSTEM menu
turns off when fast-forwarding is completed.is set to OFF (see page 7-13).
..........................................................................................................................................................................................................
1) E-E (Electric-to-Electric) signal2) E-E (Electric-to-Electric) mode
A signal that passes solely through internal circuitry, andA state in which E-E signal can be monitored.
not through pathways in which magnetic conversion takeCommonly used to monitor input signals before they are
place, such as magnetic heads and tapes.recorded.
Chapter 2 Location and Function of Parts2-3 |
ACEC
