Monitoring signals during editing
To perform automatic editing
During editing, you can monitor the following video
and audio signals on a monitor connected to the
To carry out automatic editing, press the AUTO
recorder VTR.button, turning it on, then press the REC/EDIT button.
YBetween preroll and IN points: Playback signal of
During editing the indicator above the REC/EDIT
the recorder VTR can be monitored.button lights up, and goes off at the end.
YBetween IN and OUT points: Playback signal of the
player VTR can be monitored in E-E mode.AUTO button
YBetween OUT and post-roll points: Playback signal
PREVIEW/REVIEW button
of the recorder VTR can be monitored.
The video and audio signals that can be monitored are
shown in the diagram below.
IN pointOUT point
$$REC/EDIT button
OUT button
PBEEPB
(recorder VTR)(player VTR)(recorder VTR)ENTRY button
Performing automatic editing
To stop automatic editing
Monitoring signals during editingPress the OUT button while holding down the ENTRY
button.Chapter 6 Editing
The point where the buttons are pressed is treated as an
In CONFI mode, you can monitor video and audio
signals that are just being edited.OUT point and editing stops.
Through a menu setting, you can also monitor signals
between preroll and postroll points, including portions
To confirm the results of the editing
between IN and OUT points, through the CONFI
(confidence) heads during editing.
Press the PREVIEW/REVIEW button to confirm the
The CONFI setting is made in item 017.PB/EEedit results. When the preview ends, the tape rewinds
SELECT MENU in the VTR SETUP menu.
to the OUT point, then stops.
Note
Simultaneous monitoring of video and audio signals
during editing is possible only when the HDW-500 is
installed with the optional HKDV-505 HD Editing
Processor Board.
Chapter 6 Editing6-13 |
ACEC
