3
Balancing relative volume betweenAdjust the volume of each speaker so that the test tone
from each speakers sounds the same.
speakers using Test Tone
The test tone function is useful to adjust the relative volume
between speakers.
Once the balance is set, you donOt have to change the
balance as long as the speakers arenOt moved.
< It is also possible to adjust the relative volume during playback
of DVD. See page 24 for details.
< Use the remote control from your listening position.
< The T.TONE button will not work when the SPEAKER button
< The level of the speaker emitting the test tone can be
is set to off. In that case, press the SPEAKER button to turn
changed by pressing the LEVEL buttons.
the speakers on.
< The level can be adjusted in 1 dB steps from �15 dB to +15
< The T.TONE button will not work when EXTERNAL IN is
dB.
selected. In that case, press the EXTERNAL IN button to turn it
< If you press the CH SEL (CHANNEL SELECTOR) button, the
off.
test tone stays there. To go to the next speaker, press the CH
SEL button again.
1Press the T.TONE button.
4When the setting has been finished, press the T.TONE
button to stop the test tone.
The test tone is emitted from each speaker in the following
order at 2.5-second intervals.
FL, C, FR, SR, BR, BL, SL, SW
< If certain speakers are not being used, (for example, no center
speaker) the noise sequencer will automatically skip over that
channel.
2Adjust the master volume to the normal listening level.
23 |
ACEC
