Tuner
< Make sure the antennas have been connected (see page 3).4Select the station you want to listen to (auto selection).
1Select TUNER by pressing the AUDIO button (or the
TUNER button of the remote control unit).
Hold down the TUNING/PRESET button for more than 0.5
seconds.
When a station is tuned in, the tuning process will stop
automatically.
2Select AM or FM by pressing the BAND button.
If you want to stop the tuning process, press the
TUNING/PRESET button.
Selecting stations which cannot be tuned automatically
(manual selection)
When the TUNING/PRESET button is pressed momentarily (0.5
second or less), the frequency changes by a fixed step.
FM: 50 kHz steps
AM: 9 kHz steps
Press the TUNING/PRESET button repeatedly until the station
< If the BAND button is pressed while the source other thanyou want to listen to is found.
TUNER was selected, the source will be switched to TUNER
automatically.< OTUNED� is displayed when a broadcast is correctly tuned in.
3If OPRESET� indicator is lit, press the TUNING MODE
FM MODE Button
button to select the manual tuning mode.
Pressing this button alternates between Stereo mode and
The OPRESET� indicator disappears from the display.
Mono mode.
This button is used to change the tuning mode.
Stereo:
FM stereo broadcasts are received in stereo and the OST�
indicator lights in the display.
Mono:
To compensate for weak FM stereo reception, select this
mode. Reception will now be forced monaural, reducing
unwanted noise.
24 |