Audio AdjustmentsRadio Reception
Auto Tuning
6CH DIRECT INPUT
FM MODE
1
2
SPEAKERS
BALANCE
POWER
STANDBY/ONBASS/TREBLE LOUDNESS
Tone Controls
POWER ON3 4ENGLISH
Main POWER switch and STANDBY/ON Button1. Select the TUNER function.
When the main POWER switch is ON:
Press STANDBY/ON button to turn the power on. Press2. Select the AM or FM by pressing the BAND selector
it again to turn the system off (power standby mode).button.
The indicator lights up in power standby mode and
3. Press the MODE button to change to TUNING mode.
goes out when this unit is turned on.
(The PRESET CH. indicator disappears from the
display.)
6CH DIRECT INPUT Button
I This button is used to select Tuning or Preset scan
Select this when playing a DVD. "VID3/6CH" appears on
mode.
the display. Unlike other input signals, DVD signals
deliver their own surround information, and therefore
4. Press the UP or DOWN TUNING/PRESET button
are reproduced with no direct processing by this unit.
(within 0.5 to 2 seconds). The next station
broadcasting at a frequency higher or lower than
SPEAKERS Select Buttons
that of the current station is automatically detected
With the unit in the STEREO mode, SPEAKERS A and B
and tuned in.
can be selected simultaneously. If the unit is in any of
I By pressing and holding the TUNING/PRESET button
the SURROUND MODEs, or if "VID3/6CH" (DVD 6CH) is
for longer than 2 seconds, it will continue to control
selected as the input source using the 6CH DIRECT
(three times faster than normal speed).
INPUT button, speaker system A is selected
automatically.
I FM MODE Button
BASS/TREBLE Tone Controls
Pressing this button alternates between Stereo
These two tone controls � BASS and TREBLE � can be
mode and Mono mode.
used to obtain a "flat" frequency response or a tone
Stereo
which suits your individual listening preference. The
FM stereo broadcasts are received in stereo and
BASS control adjusts low frequencies and the TREBLE
the STEREO indicator lights in the display.
control adjusts the high frequencies.
If FM broadcasts with weak signal strength are
received, the FM muting (�20 dB) function works
BALANCE Control
automatically to cut the signals, eliminating loud
This control is used to adjust the balance between the
noise.
left and right channels. Normally set to the center
Mono
position.
To compensate for weak FM stereo reception,
select this mode. Reception will now be forced
LOUDNESS Button
monaural, reducing unwanted noise.
This button compensates for the non-linear response of
I TUNED Indicator
the human ear at low volumes. Set this switch to the
''TUNED'' appears in the display when a
OFF position when listening at normal levels.
broadcast is correctly tuned in.
� 11 � |
ACEC
