AUDIO OPERATIONS
Manual TuningDirect Tuning
Using this method, the required frequency is input
FM MODEdirectly, using the numeric keys.1
2
1
POWER ON3 4
4
Manual Tuning is generally used to tune to stations
broadcasting a signal that is too weak to be received
by Auto Tuning.32
1. Select the TUNER function.
2. Select the AM or FM by pressing the BAND selector1. Press the TUNER button.
button.
2. Select the AM or FM by pressing the BAND selector
3. Press the MODE button to change to TUNING mode.button.
(The PRESET CH. indicator disappears from the
display.)3. Press the DIRECT TUNING button on the remote
control unit, ''ENTER FREQUENCY'' appears on the
4. When the UP or DOWN TUNING button is presseddisplay for a few seconds.
momentarily (0.5 second or less), the frequency
changes by a fixed step (see STEPS below).''FM---.--MHz'' or ''AM----kHz'' appears on the
display.
STEPS
FM: 50-kHz steps4. Input the frequency of the broadcast you want to
AM: 9-kHz stepshear with the numeric keys.
I If you press the DIRECT TUNING button again or
without pressing any button for 30 seconds, Direct
tuning is released.
FM: 50-kHz steps
AM: 9-kHz steps
Ex.: FM 107.55 MHz
?? ??
Ex.: AM 1008 kHz
? ? ? ?
� 12 � |
ACEC
