VIDEO OPERATIONS
Playing Video SourcesRecording with a Video Deck
Note:
Tape Dubbing (from video 1, video 2 or
video 3 to video 4)For playing video software using a certain Surround
Effect function, refer to the SURROUND EFFECTS
section.
1: Video signalstape 2 monitor OFF
1Source Indicators Lit: Video signals: Audio signals
: Audio signals
ENGLISH
POWER2ON
POWER ON
32VIDEO 1
22VIDEO 4VIDEO 2VIDEO 3
VIDEO 3VIDEO 1RecordingPlaybackPlayback
VIDEO 2
VCR/VIDEO 4
1. Turn the function (source) selector to select the
video source (video 1, video 2 or video 3) to be
recorded.
I Make sure the tape 2 monitor button is set to OFF.
2. Play back the source (VIDEO 1, VIDEO 2 or VIDEO 3).
3
3. Operate VCR/VIDEO 4 for recording. Video/audio sig-
nals from the selected VIDEO component (VIDEO 1,TV Monitor3
VIDEO 2 or VIDEO 3) can be dubbed to VCR/VIDEO 4.Speakers
Note:
1. Select the video 1, video 2, video 3 or VCR/video 4I When tape dubbing is performed, be sure to connect
mode by turning the function (source) selector.the LINE OUT (analog audio output).
2. Play the component corresponding to the function
selected.S.A.V.E. (Second Audio Source for Video
Editing) SYSTEM Function
3. The picture from the video source can be seen on the
This feature lets you replace the sound from a VCR with
TV and the sound from the video source will be
heard from the speakers.sound from an AUDIO source such as CD during video
signal dubbing.
1. Select the video source (video 1, video 2 or video 3)
by turning the function (source) selector. Wait for
more than 5 seconds and then select the audio
source with the function (source) selector.
2. Operate the selected video component and audio
component for playback, respectively.
3. Now you can watch the picture from the video com-
ponent on the TV, and listen to the sound from the
audio component through the speakers.
4. Operate VCR/VIDEO 4 for recording.
� 19 � |
ACEC
