Audio AdjustmentsRadio Reception
Auto Tuning
POWER ON
LINE STRAIGHTBASS/TREBLE
POWER ON14 3 2
SPEAKERSLOUDNESS
BALANCE
POWER STANDBY/ ON Button
1. Press the TUNER button*.Press this button to turn the power on.
* The TUNER button can also be pressed insteadPress it again to turn the system off (power standby
when you want to listen to a station selected lastmode).
by changing from another source.
The indicator lights up in power standby mode and
goes out when this unit is turned on.
2. Select the AM or FM by pressing the BAND selector
button.
SPEAKERS Select Buttons
These buttons are used to select speaker system A or B.3. Press the MODE button to change to TUNING mode.
(The PRESET CH. indicator disappears from the
LINE STRAIGHT Buttondisplay).
When this button is pressed, the signal selected by theI This button is used to select Tuning or Preset scan
source selector buttons is supplied directly to themode.
amplifier circuit, allowing you to listen to the source
with better sound quality. When the LINE STRAIGHT4. Press the UP or DOWN TUNING button (within 0.5 to
mode is selected, the BASS, TREBLE controls will be2 seconds). The next station broadcasting at a
defeated.frequency higher or lower than that of the current
station is automatically detected and tuned in.
BASS/TREBLE Tone ControlsI By pressing and holding the TUNING button for
These two tone controls � BASS and TREBLE � can belonger than 2 seconds, it will continue to control
used to obtain a "flat" frequency response or a tone(three times faster than normal speed).
which suits your individual listening preference. The
Bass control adjusts low frequencies and the TREBLEI FM MODE Button
control adjusts the high frequencies.Pressing this button alternates between Stereo
BALANCE Controlmode and Mono mode.
Stereo
This control is used to adjust the balance between theFM stereo broadcasts are received in stereo and
left and right channels. Normally set to the center posi-the STEREO indicator lights in the display.
tion.
Monophonic broadcasts are received in mono.
If FM broadcasts with weak signal strength are
LOUDNESS Buttonreceived, the FM muting (�20 dB) function works
This button compensates for the non-linear response ofautomatically to cut the signals, eliminating loud
the human ear at low volumes. Set this switch to the
noise.
OFF position when listening at normal levels.Mono
To compensate for weak FM stereo reception,
MUTING Button (on the Remote Control Unit)
Press this to mute (�20 dB) the sound from the speak-select this mode. Reception will now be forced
monaural, reducing unwanted noise.
ers and headphones when answering the telephone,I TUNED Indicator
etc.''TUNED'' appears in the display when a broad-
To restore the original volume, press the MUTING but-
cast is correctly tuned in.
ton again. While muting is engaged, the MASTER VOL-
UME level indicator will flicker.
- 12 - |
ACEC
