Troubleshooting
Basic troubleshooting of a CD player is similar to troubleshooting of any other electrical or electronic equipment. Always check the most obvious
possible causes first. To give you a few ideas of what to look for, check the following:
Problem Probable CauseRemedy
No power when POWER is pressed.Power plug not inserted securely.Plug in securely.
No playback when disc is loaded.Disc loaded with label side down.Load with label side up.
Disc dirty.Clean disc surface.
No audio output.Connection to stereo system is incorrect.Check connections.
A single tune can only be played.1/ALL button engaged.Press button to disengage it.
No program playback.PROGRAM button not pressed.Press button to display OPROGRAM�.
Mistracing (sound jumping).Player receiving vibration or shock.Change the installation position of the play-
er.ENGLISH
Disc dirty.Clean disc surface.
Hum.Pin-cord plug not connected securely.Re-connect plug securely.
Noise in tuner.Player too near tuner.Keep a reasonable distance between them
or switch off playerOs power.
Remote control unit operation is impossi-PlayerOs POWER switch set to OFF.Set switch to ON.
ble.
Batteries not inserted in remote controlInsert batteries.
unit.
Caution:
Since the unit incorporates a microcomputer, it may not operate correctly because of external noise, etc. If this happens, turn the power switch
OFF, then turn it ON again and restart operations.
� 11 � |
ACEC
