Recording
4
1 64Press the RECORD button.
3 2 5
and J indicators on the display will light, and the unit
enters record pause mode.
1Load a recordable CD-R or CD-RW disc into the unit.
< No button will work while OWAITING� is displayed. Wait a
few seconds until OWAITING� disappears from the display.
When DIGITAL is selected in step 2 , the sampling frequency
of the digital source (OFS 44_1K�, OFS 48K� or O FS 32K�)
briefly appears after OWAITING�.
< ODIN UNLOCK� appears when the unit cannot perceive the
digital signal. In that case, connect a digital device to the
DIGITAL IN terminal, switch it on, and wait a few seconds
until the unit enters record pause mode.
Press the OPEN/CLOSE button (L), place a disc on the disc
< You cannot record if OMONITOR� appears on the display. In
tray with the printed label side up, and then press the
that case, reload a recordable disc, wait a few seconds until
OPEN/CLOSE button (L) to close the disc tray.
NO TOC and OCD-R� (or OCD-RW�) indicators light on the
display, and press the RECORD button again.
Make sure NO TOC and OCD-R� (or OCD-RW�) indicators
lights on the display.
5If necessary, adjust the recording level using the REC
2Select the source to be recorded using the INPUT SELECTLEVEL buttons.
button.
DIGITAL (OPTICAL IN)
Select this to record a source connected to the DIGITAL IN
terminal.
ANALOG (ANALOG IN)
Select this to record a source connected to the ANALOG IN
Play the source to be recorded and adjust the recording level
terminal.
so that the loudest sound does not exceed the OOVER�
indicator on the peak level meter.
The level can be adjusted from � , �60 dB to +18 dB.
3If necessary, select the mode of track number
< Unlike analog equipment, digital audio units produce
assignment using the AUTO/MANUAL button.
extremely unpleasant sounds when distorted, and there is no
When the POWER button or the STANDBY/ON button is
Oheadroom� after the 0 mark. When you record digitally
pressed, this setting is reset to �60 dB.
from a commercially-produced CD, set the digital volume to 0
See page 18 for details.
dB. This will maintain all the dynamic range of the source CD
without clipping. Only boost the signal if the source is
exceptionally quiet.
When the POWER button or the OPEN/CLOSE button is
pressed, the recording level is reset to 0 dB.
16 |
ACEC
