Precaution
< Choose unit installation location carefully. Avoid
Beware of condensation
placing it in direct sunlight or close to a source of
heat. Also avoid locations subject to vibrations and
excessive dust, heat, cold or moisture. Keep awayWhen the player (or a compact disc) is moved from a
from sources that hum, such as transformers orcold to a warm place or used after a sudden
Preperationmotors.temperature change, there is the danger of
< Do not open the cabinet as this might result incondensation. Water vapor in the air could condense
damage to the circuitry or electrical shock. If aon the mechanism or the laser pickup. If droplets of
foreign object should get into the set, contact yourwater form on these parts, correct playback will be
dealer.impossible because the laser cannot read the
< When removing the power plug from the wall outlet,information from the disc correctly. To prevent this, if
always pull directly on the plug, never yank the cord.you are going to use the player in a condition where
< To keep the laser pickup clean, do not touch it, andcondensation could occur, you should leave the
do not forget to close the disc tray.player for 1 or 2 hours after plugging it into an AC
ListeningtoCDsoutlet depending on the amount of condensation. If
< Do not attempt to clean the unit with chemical
solvents as this might damage the finish. Use athis is done, the player will stabilize at the
clean, dry cloth.temperature of its surroundings.
< Keep this manual in a safe place for future
reference.
For U.S.A.
Listeningtotheradio
TO THE USER
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against interference in a residential
area. This device generates and uses radio frequency energy and if not installed and used in accordance with the
instructions, it may cause interference to radio or TV reception. If this unit does cause interference with TV or radio
reception you can try to correct the interference by one or more of the following measures:
Listeningtotapesa) Reorient or relocate the receiving antenna.
b) Increase the separation between the equipment and the receiver.
c) Plug the equipment into a different outlet so that it is not on the same circuit as the receiver.
If necessary, consult the dealer or an experienced radio/TV technician for additional suggestions.
CAUTION:
RecordingChanges or modifications to this equipment not expressly approved by TEAC CORPORATION for compliance could
void the user's authority to operate this equipment.
For CANADAPour le CANADA
AC POWER CORD CONNECTIONCORDE DE CONNEXION CA
CAUTION:ATTENTION:
Settingthetimer
TO PREVENT ELECTRIC SHOCK, MATCH WIDEPOUR ?VITER LES CHOCS ?LECTRIQUES,
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE
DANS LA BORNE CORRESPONDANTE DE
LA PRISE ET POUSSER JUSQUOAU FOND.
4 |
ACEC
