8 - Dynamics processors?DYNAMICS (master channels)
DYNAMICS (master channels)
The screen accessed by the DYNAMICS key when a The screen above shows two linked aux sends (1 and
master channel (an aux send, a buss or the stereo 2), but the same principle applies to buss masters as
master) is selected is slightly different from the well as the stereo master.
screen displayed when a channel 1-16 is selected:
Note that the following features are different from
the channel 1-16 dynamics screens:
No expander or gate available for these mas-
ter screens. Any on-screen controls associated with
these processors are therefore unavailable. This
includes the soft keys?only the compressor library
is available from these screens.
Insert point The insert point is fixed to pre-fader.
Linking The way in which the links are labeled is
different for master modules. Instead of the channels
being referred to as left and right, they are referred to
as 1and 2 (?left? and ?right? do not have any real
meaning in these cases).
Assigning processors to master channels
The assignment of stereo compressors to up to three Use the fourth soft key to bring up the master assign-
master channels is done using the I/O display ASSIGN ment section.
SECT. sub-screenMove the cursor to the second column (MASTER
COMP INSERT MATRIX), and use the dial to assign the
possible master channels (confirm with ENTER).
NOTE
The stereo master counts as two channels, as shown in
the sample screen here.
TASCAM DM-24 Reference Manual 65 |
ACEC
