Advanced techniques
Event numbering starts at 0?START UP at the bottom of the history list
(you can?t undo this!)
The top line is the most recent event.
When you undo, you undo the action pointed to by the cursor (/) and
all actions after it. You can?t undo just one action in the middle of the
history list.
?Use the wheel to scroll up and down through the list until you come to
the action you want to undo (together with all the actions that have
been done since then).
?Press ENTER to leave the list, and the status of the DP-01 changes to
the status that it had immediately after the highlighted operation in
the list was performed.
Note that the actions above the undo point do not disappear, and that
an arrow symbol appears to the right of the undo point.
Redoing an action If you make a mistake undoing an action, you can In order to redo an
undo the undo (that is, you redo the action).action, you must
have undone an action first!
?Press and hold the SHIFT key and press the UNDO (REDO) key to redo
the last undone action.
or
Press and hold the UNDO key (no SHIFT) to bring up the the UNDO/REDO
screen:
-UNDO / REDO -
C OPY PA STE ?2
/R ECORDI NG1
- START UP-0
You can scroll down to the position marked by the left-pointing arrow
(to the right of the list), which marks the furthest point in the history
at which you can perform a redo operation.
Press ENTER to redo the selected undone actions.
About track editing
TASCAM DP-01 Owner?s Manual 51 |
ACEC
