Restoring factory settingsODTS� and ODTS 96/24� are trademarks of Digital Theater
If you have made a lot of changes to the setup, and want toSystems, Inc.
restart from a known set of options, restore the unit to the
factory settings as follows:Manufactured under license from Dolby Laboratories.
ODolby�, OPro Logic� and the double-D symbol are
trademarks of Dolby Laboratories.
OSuper Audio CD� is a registered trademark.
ODSD� is a registered trademark.
HDMI, the HDMI logo and High-Definition Multimedia
Interface are trademarks or registered trademarks of HDMI
Licensing LLC.
1. Turn the unit off and wait 30 seconds or longer.
This product incorporates copyright protection technology that
is protected by method claims of certain U.S. patents andENGLISH
2. Press the STANDBY/ON button while holding down theother intellectual property rights owned by Macrovision
STOP button.Corporation and other rights owners. Use of this copyright
Release the STOP button when OSetup CLR� appears on theprotection technology must be authorized by Macrovision
display.Corporation, and is intended for home and other limited
viewing uses only, unless otherwise authorized by Macrovision
All memories are erased, and the unit returns to the factoryCorporation. Reverse engineering or disassembly is prohibited.
settings.
The DV-60 player uses six DACs with high-quality 14-bit
216MHz processing for video output. This type of DAC, the
ADV7314, employs new Noise shaping Video (NSV)
technology from Analog Devices, Inc. of the USA.
Changing the Color System (NTSC/PAL)
NSV technology uses multi-bit delta-sigma conversion,
If you experience picture distortion or are unable to view the
removing video noise and providing low noise and high
monitor image, you may need to change the color setting to
linearity, without the loss of information that is often
match your TV.associated with analog filtering systems.
Noise Shaped Video and NSV are registered trademarks of
1. Turn the unit off.
Analog Devices, Inc.
2. While holding down the PAUSE button of the main unit, press
the STANDBY/ON button.
To eliminate Ojaggies� and produce clear natural images, the
3. While OV Set NTSC� (or OV Set PAL�) is displayed on the front
DV-60 uses DCDi (Directional Correlational Deinterlacing)
panel display, press the / button.technology. The circuits employed are from the Faroudja
The display changes to OV Set PAL� (or OV Set NTSC�).
business devision of Genesis Microchip, and enable hardware
Select OV Set PAL� when a PAL TV (European standard) is
based diagonal line detection and smoothing from a pixel
connected. Select OV Set NTSC� when a NTSC TV (Americanbased image. As a result, smoother progressive-scan images
standard) is connected.
can be produced, with Ojaggie� noise reduced by interpolation
4. Press the STANDBY/ON button to turn the unit off.
techniques.
Note that you have to turn the unit off before each change.
About MOD.(Modulation) PAL:
Most models of the newly developed countdown PAL TV
system detect 50 Hz (PAL)/60 Hz (NTSC) and automatically
switch vertical amplitude, resulting in a display without
vertical shrinkage.
If your PAL TV does not have a V-Hold control, you may not
be able to view NTSC disc because the picture may roll. If the
TV has a V-Hold control, adjust it until the picture stops
rolling. On some TVs, the picture may shrink vertically, leaving
black bands at the top and bottom of the screen. This is not a
malfunction; it is caused by the NTSC-PAL conversion.
5 |
ACEC
