Before Use
Conventions about This ManualRead this before operation
< Instructions in this manual describe the controls on the remote< As the unit may become warm during operation, always leave
control. You can also use the buttons on the front panel if theysufficient space above the unit for ventilation.
have the same or similar names as those on the remote.< The voltage supplied to the unit should match the voltage as
< The types of functions and operations that can be used for aprinted on the rear panel. If you are in any doubt regarding this
particular disc vary depending on the features of that disc. Inmatter, consult an electrician.
some cases, these functions and operations may differ from the< Choose the installation location of your unit carefully. Avoid
descriptions given in this Owner's Manual. In this event, followplacing it in direct sunlight or close to a source of heat. Also
the instructions given on the screen. This Owner's Manual onlyavoid locations subject to vibrations and excessive dust, heat,
covers basic disc operations.cold or moisture.
< For some operations, the PROHIBIT icon " " may appear on the< Do not place the unit on any high heat-producing units like your
screen. This indicates that the operation described in thisamplifier/receiver.
Operations Manual is not permitted for the current disc.< Do not open the cabinet as this might result in damage to the
< The drawings about the TV screen and front panel display usedcircuitry or electrical shock. If a foreign object should get into the
in this Operations Manual are purely for the purposes ofset, contact your dealer.
explanation. The actual displays may differ slightly from what are< When removing the power plug from the wall outlet, always pull
shown here.directly on the plug, never yank the cord.
< To keep the laser pickup clean, do not touch it, and do not forget
to close the disc tray.
< Do not attempt to clean the unit with chemical solvents as this
might damage the finish. Use a clean, dry cloth.Beware of condensation
< Keep this manual in a safe place for future reference.
When the unit (or a disc) is moved from a cold to a warm place,
or used after a sudden temperature change, there is a danger ofDO NOT MOVE THE UNIT DURING PLAYBACK
condensation; vapor in the air could condense on the internal
During playback, the disc rotates at high speed. Do NOT lift or
move the unit during playback. Doing so may damage the disc.mechanism, making correct operation impossible. To prevent
this, or if this occurs, leave the unit for one or two hours with the
WHEN MOVING THIS UNITpower turned on. Then the unit will stabilize at the temperature of
its surroundings.
When changing places of installation or packing the unit for
moving, be sure to remove the disc and return the disc table to its
original position in the player. Then, press the power switch to
turn the power off, and disconnect the power cord. Moving this
Maintenance
unit with the disc loaded may result in damage to this unit.
If the surface of the unit gets dirty, wipe with a soft cloth or use
diluted neutral cleaning liquid. Be sure to remove any fluid
completely. Do not use thinner, benzine or alcohol as they may
damage the surface of the unit.
CAUTIONCAUTION Regarding Placement
The product shall not be exposed to dripping or splashing andTo maintain proper ventilation, be sure to leave a space around
that no object filled with liquids, such as vases, shall be placed onthe unit (from the largest outer dimensions including
the product.projections) equal to, or greater than, shown below.
Left and Right sides: 4� (10 cm)
Do not install this equipment in a confined space such as a bookRear Panel: 4� (10 cm)
case or similar unit.Top Panel: 20� (50 cm)
4 |
ACEC
