Connections and controls
A wide variety of external equipment can be connected via the sockets located on the side of the TV.
Whilst all the necessary adjustments and controls for the TV are made using the remote control, the buttons on
the TV may be used for some functions.
Standby Button
DONOT connect a
standard video cable
AND an S-Video cable to
EXT 2 at the same time.
RED � Standby
Green � On
!DO NOT connect equipment
B2 terminals
to both the side
at the same time.
Switching onUsing the controls and connections
If the power-on light is unlit check the adaptor isTo alter the volume press Nj+.
connected and the power switched on.
To alter the programme position press eeFff.
To put the set into Standby press ion the remote
control. To view the TV press iagain. The picture mayWhen connecting mono sound equipment to EXT2,
take a few seconds to appear. Standby should only beconnect the audio output of the equipmenttothe
used for short periods of time.L(Mono)socket onthe TV.
To set up the TV you will now need to use the on-screenTo select the Input, press Buntil the display shows
menus. Press the MENU button on the remote control toEXT1as described on page 10. The TV will automatically
see the menus. sense the type of signal.
The menu bar at the top of the screens will show fivePlease always refer to the ownerOs manual of the
different topics shown in symbols. As each symbol isequipment to be connected for full details.
selected by pressing the Sor Rbutton on the remote
control, its respective options will appear below.
To use the options press the Q button on the remote
control to move down through them and Sor Rto select
the required choice or adjust a setting. The functions of
each menu are described in detail throughout the
manual.
7 |
ACEC
