Adjusting the picture
The picture settings have been adjusted by theIf the picture is not to your liking, make the following adjustments
factory under optimum signal receptionusing the remote control.
conditions, however conditions may not be the
same in your area. After turning on your
Press MENU on your remote
television, allow it to warm up for a few1
control. The on screenON/OFF TIMER
minutes before making any adjustments.
SETUP
display will appear.
PICTURE
SOUND
NICAM AUTO OFF
EXT COLOUR AUTO
CALLLANGUAGE
PANEL LOCK ON OFF
EXT2 SET
PRESS : / / OK / MENU
2Press P or P to select
ON/OFF TIMER
picture menu.
SETUP
PICTURE
P
SOUND
Press OK to select adjustment
NICAM AUTO OFF
screens.EXT COLOUR AUTO
LANGUAGE
PANEL LOCK ON OFF
OKEXT2 SET
PRESS : / / OK / MENU
P
Press P to view brightness, contrast, colour or sharpness
3
on screen displays. (Tint menu will be displayed when an
NTSC signal is input on SCART.)
Press +/� to adjust the
levels.
YPictures appear sharpest in
the daytime by increasing
the contrast. In the eveningBRIGHTNESS32
(when surroundings are
darker) the sharpest picturePRESS : +/�/ / / MENU
can be obtained by reducing
the contrast.
4Press MENU twice to remove
the picture menu from the
screen.
YIf you do not make an
adjustment within 1 minute
ON
the menu will disappear.
NOTE :
Should you wish to reset picture controls to
PICTURE ADJUSTMENT :
factory settings (MODE-1/MODE-2/MODE-3),
Your preferable picture contrast can be selected by pressing
press to select your preferable picture
(Selectable Picture) button repeatedly.
contrast.
PICTURE
PICTUREPICTUREPICTURE
MODE-M
MODE-1MODE-2MODE-3
(UserOs Settings)
12
3K60901A P.08-131219/3/2002, 9:26 |