SETTING UP
To conserve energy, do
not leave the set in
Connecting and turning
Standby for long periods
of time.
on your new TV
Before connecting any external equipment, turn off all main power switches.
The TV back connections��switching on�
WE RECOMMEND THAT YOU USE SCART
28Z23G / 28Z23B / 28Z27B models:
LEADS IN ADDITION TO AERIAL CABLES
On the FRONT of the TV:
WHEREVER POSSIBLE
If the red power-on light on the front is unlit, press the POWER
button on the FRONT to switch the set on, then press a number
Aerial cables:
button on the remote control to see the screen.
Connect the aerial to the socket on the rear of
the television. If you use a decoder* and/or a
video recorder it is essential that the aerial cable
is connected through the decoder and/or through
the video recorder to the television.
Power Button
Scart leads:
Connect the video recorder IN/OUT socket to the
TV. Connect the decoder TV socket to the TV.
GREEN = On Timer is setRED = Power On
Connect the video recorder SAT socket to the
decoder VCR socket.
32Z23G / 32Z23B / 32Z27B models:
Before running Auto tuningput your decoder
With the controls on the SIDE of the TV:
and video recorder into Standby.
If the red power-on light on the front is unlit, press the POWER
button on the SIDE to switch the set on, then press a number
button on the remote control to see the screen.
the back of your TV
Power button
SCART 2
SCART 1
decoder*
IN
OUT
TVVCRGREEN = On Timer is setRED = Power On
IN
OUT�and with the remote control:
IN/OUTSAT
video recorderPress the Standby Buttoni:
This allows you to put the set into
standby mode when leaving the TV
*a decoder could be:unattended for short periods of time. To return to TV mode
Digital Satellite, Analoguepress the button, or any of the numbered buttons on the
i
Satellite, or any otherremote control. The picture may take a few seconds to appear.
compatible decoder.
5 |
ACEC
