The timer, time display,
input selection and AV connections
Defining the INPUT and OUTPUT sockets so
The Timer
that the television recognises connected
equipment. See page 6 for a clear view of the
The television can be set to turn itself OFF after a back connection recommendations.
certain time.
Most VCRs and decoders send a signal through the
Select Timer from the top menu bar.
1
SCART lead to switch the television to the correct Input
socket. Alternatively press the external source selection
button Buntil the picture from connected equipment is
shown.
An S in the display e.g. EXT2S, indicates the input is set
Timer
for an S-Video signal.
Off timer00:00
0 � 9 : To set
Input selection
EXIT : To exit
Press Q to select Off timer. Use the numberUse the Input Selection if the television does not switch
2
buttons to set the required time. For example, toover automatically.
switch the television off in one and a half hours
enter 01:30, or use Sand R to increase/decreasePress B to select EXT1, EXT2 or EXT3.
1
in steps of 30 minutes.
To return to television mode press B again or
2
Press EXIT to finish.one of the numbered buttons.
3
To turn the television back on press ior one of
the number buttons.
INPUT signal selection
This specifies the type of signal going into SCART 2
The Time Display
(EXT2) on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
The time display facility allows the current time to be seen
on the television screen.From the Set up menu select EXT2 input
1
and with S or R select either AV or
Press 8/9 whilst watching a normal televisionS-VIDEO as the required input.
broadcast to see a time display from the broadcaster. It
will remain on screen for about 5 seconds.
If the colour is missing try the alternative setting.
Set up
LanguagezENGLISH x
Auto tuningx
Manual tuningx
Programme sortingx
EXT2 input zAVx
Horizontal positionzx
EXIT :To exit
16 |
ACEC
