SETTING UP
Connecting and turning on
your new TV
To conserve energy it is best to turn your TV off and not to leave it in Standby, unless the timer has been set.
The TV back connections�
Connect the aerial to the socket on the rear of the television. If you use a Set Top Box and/or a video recorder it is essential that the
aerial cable is connected through the Set Top Box and/or through the video recorder to the television.
DO NOT CONNECT SCART LEADS UNTIL THE TELEVISION IS FULLY TUNED.
a SET TOP BOX could be:
*
Digital Satellite, Analogue
the back of your TV
Satellite, or any other
COMPONENTCOMPONENTVIDEO INPUTVIDEO INPUT
compatible decoder.
YY
Pa/CaPa/Ca
Pr/CrPr/CrAUDIOAUDIO
Aerial
(AUDIO/VIDEO)(AUDIO/VIDEO)(AUDIO/VIDEO)(AUDIO/VIDEO)
SET TOP BOX*Video Recorder
ININ
OUTOUT
Aerial Cable
Aerial Cable
�and switching your new TV on�
On the front of the TV�
If the red power-on light is unlit, press the POWER button on the front of
the TV to switch the set on and then press a number button on the remote
control to see the screen.
�and with the remote control:
Press the Standby Buttoni:
This allows you to put the set into
standby mode when leaving the TV
RED = Power Onunattended for short periods of time. To
return to TV mode press the ibutton,
GREEN = On Timer is setor any of the numbered buttons on the
remote control. The picture may take
a few seconds to appear.
ORANGE = Dual language
To conserve energy, do not leave the
being received
set in Standby for long periods of time.
GREEN = Stereo signal being received
5 |
ACEC
