GENERAL ADJUSTMENTS
SPECIFIC INFORMATIONS
(2)GREEN: Internal crosshatch signal (white crosshatch on black background) (3)User adjustment: Dynamic mode, cinema mode (4) Carry out electrical focus and lens focus after rough adjustment. (5) Use the jig to protect everything, except the color subjected to adjustment, from exposure to light.
Focus adjustment method (1/2)
set on the screen.until immediately before the cutoff adjustment in order to stabilize the GOs coupling liquid temperature.
Carry out anticipated adjustment on the G lens, considering the time until the lens focus stabilizes. The level of anticipated adjustment on the G lens results in a required level of correction, if an adjustment point is During a heat run, be sure to keep lower the GOs screen VR of the focus pack from turning on the power of the set
each R and B projection tube to the position where the center of the screen gets optimally focused.G so that the vertical scanning lines on the screen center can appear most clearly.best possible focus.yxc
Conditions:(1)RED, BLUE: Internal Retoma signals (PAL)(1)Receive the internal Retoma signals, use the focus VR of the focus pack (Z410), and adjust the electrical focus of(2)Receive the internal crosshatch signals, use the focus VR of the focus pack (Z410), and adjust the electrical focus of(1)R, B: Receive the internal Retoma signals, watch the screen center and its periphery, and make adjustment to the(2)G: Adjust this by the method introduced in the next page.
Electrical focusLens focus(Precautions)
ModelAdjustment pointsAdjustment methods
40PW03G 40PW03B
� 18 � |
ACEC
