Remote Control Batteries
Requires two R6 batteries.
1. Turn the transmitter face down.2. Install the batteries as shown in3. Replace the cover and slide in
Press and slide off the batterythe battery compartment.reverse until the lock snaps.
cover.(Polarity + or � must match the
markings in the compartment.)
Two "R6" size
Helpful Hint:
For frequent remote control users, replace old batteries with
Alkaline batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: OZinc Carbon� with OAlkaline�).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.
8 |
ACEC
