Connections and controls
A wide variety of external equipment can be connected via the sockets located behind the door on the right
side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
touch controls on the front of the television may be used for some functions.
INPUT5
(EXT 5)
EXITMENU
Standby
RED LED� Power On
GREEN LED
Switching onUsing the controls and connections
If the red LED is unlit check that the mains plug isTo alter the volume press Nj+.
connected to the power supply. If the picture does not
appear press a number button on the remote control, itTo alter the programme position press eeFff.
may take a few seconds.
Press MENU and S, R, Q or P to control the sound
To put the television into Standby press ion the remoteand picture options.
control. To view the television press iagain or any of
the number buttons. The picture may take a few secondsPress EXIT to finish.
to appear.
When connecting mono sound equipment to EXT5,
To set up the television you will now need to use the
connect the audio output of the equipmenttothe
on-screen menus. Press the MENU button on the
L/Monosocket onthe television.
remote control to see the menus.
The menu bar at the top of the screens will show fiveTo select the Input, press Buntil the display shows
different topics shown in symbols. As each symbol isEXT5 as described on page 19. The television will
selected by pressing the Sor Rbutton on the remoteautomatically sense the type of signal.
control, its respective options will appear below.
Please always refer to the ownerOs manual of the
To use the options press the Q button on the remoteequipment to be connected for full details.
control to move down through them and OK, Sor Rto
select the required choice. Follow the on screenPlease note: Inserting the headphone jack will mute the
instructions. The functions of each menu are described insound from all speakers.
detail throughout the manual.
8 |
ACEC
