Input selection and AV connections
Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 7
for a clear view of the back connection recommendations.
Most VCRs and decoders send a signal through the SCART
OUTPUT signal selection for SCART 3
lead to switch the television to the correct Input socket.
Alternatively press the external source selection button B
until the picture from connected equipment is shown.
This enables selection of the source to output from
SCART 3. For example, to record transmissions in stereo
An S in the display e.g. B3S (EXT 3S), indicates the
from a stereo decoder � connect a stereo decoder to
input is set for an S-Video signal.
SCART 1 and stereo VCR to SCART 3, then select EXT 1
as the EXT3 output. The signal received through
SCART 1 will output directly through SCART 3.
Input selection
Select AV connection.
1
Use the Input Selection if the television does not switch
over automatically.AV connection
EXT3 inputAV
Press B to select B1, B2, B3, or B4 EXT3 outputEXT1
1
(EXT 1-4).WooferInt.
Audio outputFixed
To return to television mode press Bagain or
2
one of the numbered buttons.
EXIT :To exit
INPUT signal selection
Use Sor Rto change the EXT3 output option to:
2
Monitor = The picture on screen.
This specifies the type of signal going into SCART 3 (EXT3)
TV = The last television programme selection.
on the back of the television. Please refer to the
EXT1 = The picture from equipment connected to
manufacturers instructions for the connected equipment.
SCART 1.
EXT2 = The picture from equipment connected to
In the SET UP menu press Q until
1SCART 2.
REXT4 = The picture from equipment connected toAV connection is highlighted, then press .
With S or R select either AV or S-VIDEO as the
the front/side input sockets.
required inputfor EXT3.
If the colour is missing try the alternative setting.
AV connection
EXT3 inputAV
EXT3 outputEXT1
WooferInt.
Audio outputFixed
EXIT :To exit
17 |
ACEC
