Introduction
Set up
This manual applies to models CE27T11, CE32T11 and CE36T11, and there are slight differences among them.
The CE32T11 is the model used for illustration purposes. Instructions in this manual are based on using the Remote
Control. Check the model of your TV before using this manual.
Exploring your new TV
You can operate your TV using the buttons on the front panel or the Remote Control.
The back panel provides all the terminal connections you will need to connect other equipment to your TV.
Model CE27T11 is not equipped with an S-VIDEO IN jack.
PreparationCE36T11
CE32T11POWER
MTS
CE27T11TIMER
TVCABLEVCR
123
CH
456
789
CH RTNVOL
1000ENT
C.CAPTRESET
XDSURSEXIT
POWERADV
FAVMENUFAV-+
Basic Operation
ADV
Back panelMUTE RECALL TV/VIDEOSURROUND
STOP SOURCEPLAY PIP
CE27T11CE32T11/CE36T11
INOUTREC TV/VCR REWFF
VIDEO1VIDEO2ANT
VIDEOVIDEOVIDEO(75&)STILL LOCATE SWAP
VIDEOVIDEO
L/L/L/
ANTMONOMONOMONOL/
(75&)
MONOL/MONOS-VIDEO
AUDIOAUDIOAUDIOAUDIOAUDIO
RRRRR
VIDEO1 VIDEO2
INOUT
Advanced Operation
Selecting a location for the TVCaution :
The plug has one prong wider than the other
Place the TV on the floor or on a sturdy platform in a locationand will fit only one way into a standard
where light does not directly hit the screen.electrical outlet (120 volt AC, 60 Hz). If the
plug does not fit into the outlet, try turning it
Place the TV far enough from the walls to allow proper
around. If the plug still does not fit, the outlet
ventilation. Inadequate ventilation may cause overheating,
is probably non-standard and must be
Reference Section
which may damage the TV.
replaced by a qualified electrician. Do not
tamper with the plug or try to force it into a
WARNINGnon-standard outlet.
To avoid personal injury:
Do not stand or climb on the TV.Wide prong
Do not put a VCR or any heavy object on top of the TV.
4 |
ACEC
