Maintenance and cleaning
Clean the external surfaces of the machine and control panel8. Place the coarse/fine filter in the microfilter and press
with a damp soft cloth. If necessary use only neutraltogether.
detergents. Never use abrasive products, scouring pads or
9. Put the filter combination in place and lock by turning the
solvent (acetone, trichloroethylene etc....).
handle clockwise to the stop. During this process ensure
Ensure that the seals around the door, the detergent and rinse
that the flat filter does not protrude above the base of the
aid dispensers are cleaned regularly with a damp cloth.
washing compartment.
We recommend every 3 months to run a 65°C wash
programme without dishes using detergent.
Under no circumstances may the dishwasher be used
without filters.
Cleaning the filters
To ensure a correct
The filters in the base of the washing compartment are to a
working of the dishwasher,
large extent self-cleaning. Nevertheless the filters should be
NEVER try to remove the
checked and cleaned from time to time. Dirty filters will
upper spray arm.
degrade the washing result.
If residues of soil have
clogged the holes in the
1. Open the door, remove the lower basket.upper spray arm, remove
them with a toothpick.
2. The dishwasher filter system comprises a coarse/fine filter
MA33
(A/B), a microfilter (C) and a flat filter (D).
Some dishwasher models filter system comprises only a
coarse filter (A), a microfilter (C) and a flat filter (D).
Unlock the filter system using the handle on the microfilter,
and remove.Prolonged periods of non-operation
If you are not using the machine for any period of time you are
advised to:
1.Unplug the appliance and then turn off the water.
2.Fill the rinse aid dispenser.
3.Leave the door ajar to prevent the formation of any
unpleasant smells.
4.Leave the inside of the machine clean.
Frost precautions
Avoid placing the machine in a location where the temperature
MA35
MA32is below 0°C. If this is unavoidable, empty the machine, close
1the appliance door, disconnect the water inlet pipe and empty
3. Turn the handle about /4 a turn anticlockwise and remove.
it.
Moving the machine
If you have to move the machine (moving house etc....):
1. Unplug it.
2.Turn the water tap off.
MA363.Remove the water inlet and discharge hoses.
4.Pull the machine out together with the hoses.
4. Take hold of the coarse/fine filter (A/B) by the handle with Avoid over tilting the machine during transportation.
the hole and remove from the microfilter (C).
5. Clean all filters thoroughly under running water.
6. Remove the flat filter (D) from the base of the washing
compartment and clean both faces thoroughly.
MA31
7. Put the flat filter back in the base of the washing
compartment.
13 |
ACEC
